Want this question answered?
A three-phase separator is used in the oil industry to separate oil, water and gas from a mixture.
water separator removes water (liquid) but moisture separator removes water vapor
emulsifier. Also, a device that removes oil from water, or water from oil - depending upon its application.
Something that desalinates salt from water especially from sea water
Separator design can be complex. I will just cover the basics. Crude oil from a well needs to be cleaned up, that is removal water and gas, so that it can be sold. The horizontal separator has an inlet at one end, where the crude oil enters. In a three phase separator, the gas will separate from the oil due to the lower pressure in the vessel and flow out of an outlet in the top of the separator. Water is generally less dense than oil so it will settle in the bottom of the vessel. A water level controller is needed to make sure the oil does not drain out the bottom. A diagram of a horizontal separator is shown in the following link: http://www.glossary.oilfield.slb.com/Display.cfm?Term=separator Why do I say that the design is complex? A common problem is that the gas can entrain some of the oil if the velocity of gas is high in the separator. Baffles are designed to prevent this. The separator never perfectly separates the gas and water from the oil, and a staged separation system may be needed. Gas to be saleable may need to be dehydrated after separation. The water may contain oil, and need additional clean up before disposal. See: http://www.natcogroup.com/Content.asp?t=ProductPage&ProductID=33 The Society of Petroleum Engineering (spe.org) has a number of textbooks on this topic (facility design) for sale.
A three-phase separator is used in the oil industry to separate oil, water and gas from a mixture.
water separator removes water (liquid) but moisture separator removes water vapor
circuit of bilge oil water separator
a salt separator a salt separator
emulsifier. Also, a device that removes oil from water, or water from oil - depending upon its application.
because the waste dumped in the water.
3000
Something that desalinates salt from water especially from sea water
the function of gas-oil separator is to separate the production fluids into their constituents such as oil, gas and water
The separator is valve handle is on the firewall side of the fuel canister
Separator design can be complex. I will just cover the basics. Crude oil from a well needs to be cleaned up, that is removal water and gas, so that it can be sold. The horizontal separator has an inlet at one end, where the crude oil enters. In a three phase separator, the gas will separate from the oil due to the lower pressure in the vessel and flow out of an outlet in the top of the separator. Water is generally less dense than oil so it will settle in the bottom of the vessel. A water level controller is needed to make sure the oil does not drain out the bottom. A diagram of a horizontal separator is shown in the following link: http://www.glossary.oilfield.slb.com/Display.cfm?Term=separator Why do I say that the design is complex? A common problem is that the gas can entrain some of the oil if the velocity of gas is high in the separator. Baffles are designed to prevent this. The separator never perfectly separates the gas and water from the oil, and a staged separation system may be needed. Gas to be saleable may need to be dehydrated after separation. The water may contain oil, and need additional clean up before disposal. See: http://www.natcogroup.com/Content.asp?t=ProductPage&ProductID=33 The Society of Petroleum Engineering (spe.org) has a number of textbooks on this topic (facility design) for sale.
Located in front of the fuel filter you will find a yellow lever-like switch if you rotate the switch clockwise it will drain the fuel-water separator.