answersLogoWhite

0

ummmm mayb u should rub it like ur jackin off nd itl warm up buddy

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Why would a Honda Passport's heater blow cold air and you smell antifreeze?

Probably - your head gasket is blown. Antifreeze will be coming out of the tail (exhaust) pipe.


How do you eliminate condensation on vent pipe?

Look at where the cold air is coming from and see if it can be stopped, if not insulate the pipe.


How can you make your 6.4L powerstrokes exhaust loud?

straight pipe and cold air intake will make it loud straight pipe cold air intake and bigger turbo will make it really loud if you point the exhaust face the ground right after the back axle then it will make it louder also


What is the pipe that runs from the exhaust manifold to the air cleaner intake?

The pipe that runs from the exhaust manifold to the air cleaner intake is commonly referred to as the exhaust heat riser or heat stove pipe. Its purpose is to channel warm air from the exhaust manifold to the air cleaner, aiding in the vaporization of fuel in cold weather to improve engine performance during startup. This system helps prevent carburetor icing and ensures smoother engine operation in low-temperature conditions.


How much horsepower does a 1992 Mitsubishi 3000gt have?

ABout 161 hp out of the factory with mods such as exhaust headers and wide pipe with cold air intake its about 218.


Pipe that comes out of the exhaust manifold?

That is the charge air pipe.It has four nuts where is connects onto the exhaust manifold and also ties into the exhaust collector mounted directly below going to the exhaust system.The charge air pipe goes to the housing on the front of the air cleaner housing which has three air filters inside the housing.


Why is water dripping from my furnace exhaust pipe?

Water dripping from your furnace exhaust pipe could be a sign of condensation buildup. When the hot exhaust gases from the furnace come into contact with the cold air outside, it can cause moisture to form and drip from the pipe. This is a common occurrence and usually not a cause for concern. However, if you notice a significant amount of water or if it is accompanied by other issues like a blockage in the pipe, it may be a good idea to have a professional inspect and address the problem.


Where is the EGR valve on a 2000 ford E250 4.2 6cyl?

The EGR valve is a exhaust gas recirculation valve. Look for a 3/4 inch pipe, with insulation around it, coming from some part of the exhaust pipe. You need to remove the air filter to see it. On my 2001 Ford Van, it come up along the passengers side of the engine to the valve. 2 smaller tubes, coming up off this pipe,are connected to a switch for the EGR valve, on my 2001 Van. The Valve itself is round on top. The 3/4 inch pipe comes up to it. If you can't see the pipe, with the engine cold, feel it come up to the EGR valve. The EGR valve is on the top of the engine, behind the air filter. From the front it is next, but lower thanthe air intake clamped to the intake manifold. It is round with possible a number sticked in top of it.


Why does the cold line sweat?

The cold-water pipe chills the air immediately surrounding it. The cold air cannot support the same amount of moisture that warm air can, so the water vapor condenses out and sticks to the pipe.


Why does your ac PVC drain pipe blows out cold air?

That drain pipe is meant to remove condensed water from the chmber where the air is blown through the system, if there is air coming through there it just means there is no water in the line that has condensed. many units turn the drain tube upward slightly so a little water always stays in the pipe pereventing the escape of cold air. It works like a P trap on your sink.


How cold is the air coming out of the vents when the air is on?

It's somewhat cold. It's just very little cold air coming out. Can't hear the vent blow the air as well.


What the cause of a poping noise coming from the muffler?

overfueling, ignition/valve timing out, or hopefully just air leaking through knackered exhaust gasket into pipe, all causing secondary combustion.