It is important to maintain a vacuum in a condenser if you want it to work well.
Unlike a static condenser (capacitor bank), the value of reactive power from a synchronous condenser can be continuously adjusted. A synchronous condenser also has other advantages over static condensers such as: - not being affecting by harmonics (some harmonics can even be absorbed by a synch condenser) - producing no switching transients
The reason why it is called a barometric condenser is because it makes contact and it is a long vertical pipe into which it condensates and cools the liquid flow to accomplish the removal of pressure. It is also stated that when the pump is used the system is called a low level barometric condenser.
condenser approach is heat transfer the water to gas of condenser efficiency is good less then below (2 F) the system is working good.
There are several roles of a condenser system depending on what is using it. In a microscope, a condenser system helps gather and focus light for a clearer view. In an air conditioner a condenser system cools heated gas so it can be used again.
Importance to keep inner tubes of condenser cold
Importance to keep inner tubes of condenser cold
Liebig condenser, Vigreaux column, Snyder column, West condenser, Allihn condenser, Graham condenser, Dimroth condenser, Friedrichs condenser. There are no shortage of these!
to measure the temperature of the vapour accurately
A condenser is a device which condenses the steam at the exhaust of turbine. Condensers are classified in to two types.Such as (1) Jet condenser (2) Surface condenser It serves important functions. Such as 1. The condenser enables the recovery and recirculation of pure feed water into the plant. Thus, (i)The cost of water softening plant is reduced and (ii) It also saves the cost of fresh water to be supplied to the boiler.
It is important to maintain a vacuum in a condenser if you want it to work well.
Which condenser are you asking about? There are a couple things that are called a condenser.
If the vacuum in the surface condenser it very high, it results in higher practical thermal efficiency. It is important for you to keep the temperature to 100 Celsius or lower for it to work properly.
Condenser
Drain the cooling system.Remove the radiator.Recover the refrigerant.Remove the receiver dryer.Remove the condenser inlet hose bolt.Remove the condenser inlet hose.Remove the condenser outlet hose bolt.Remove the condenser outlet hose.Remove the condenser from mounts on the radiator.Remove the condenser...........................
There is only one condenser. That would be an air condenser.
What are the symptoms of an cooled Condenser when the air leaving the condenser is hitting a barrier and recirculating?