It isn't necessarily the case. In the UK electricity distribution system, you have 33/11-kV step-down tranformers (where 11 kV is the secondary side) or 11-kV/400-230-V step-up Transformers (where 11 kV is the primary side).
It depends what you mean by an '11-kV transformer'; do you mean a primary transformer (33/11-kV transformer) or a distribution transformer (11-kV/400-230-V transformer). Differential protection IS offered on primary transformers.
It depends on the design of the transformer but 1 MVA is a common size for an 11 kV / 415 v three-phase transformer.
Primary substation - when the transformer is HV/MV or MV/MV. e.g. substation designed for 132kV/33kV or 230kV/22kV or 33kV/11kV etc stepped down for MV distribution (mainly for utilities and heacy industries) Secondary substation - when the transformer is HV/LV or MV/LV. e.g. substation designed for 11kV/400V or 6.6kV/400V etc stepped down for LV distribution (mainly for residential, commercial) sometime referred to as a kiosk substation.
Possibly... but only a trained electrical technician would be licensed to do that kind of work!
High Tension transformer means (HT) high voltage transformer.
It depends what you mean by an '11-kV transformer'; do you mean a primary transformer (33/11-kV transformer) or a distribution transformer (11-kV/400-230-V transformer). Differential protection IS offered on primary transformers.
It depends on the design of the transformer but 1 MVA is a common size for an 11 kV / 415 v three-phase transformer.
The higher voltage it transformed to a lower voltage by the use of a step down transformer.
Primary substation - when the transformer is HV/MV or MV/MV. e.g. substation designed for 132kV/33kV or 230kV/22kV or 33kV/11kV etc stepped down for MV distribution (mainly for utilities and heacy industries) Secondary substation - when the transformer is HV/LV or MV/LV. e.g. substation designed for 11kV/400V or 6.6kV/400V etc stepped down for LV distribution (mainly for residential, commercial) sometime referred to as a kiosk substation.
Possibly... but only a trained electrical technician would be licensed to do that kind of work!
This isn't the case. You can have aluminium or copper on primary or secondary side of a transformer.
Because the tranformer calculation for ratings is calculated with the formfactor which is 1.11 constant. Regards Mithin kudva
The incoming voltage from the source to the transformer is called primary voltage.
The primary winding of a transformer is connected to the supply, while the secondary winding is connected to the load.
High Tension transformer means (HT) high voltage transformer.
You will have a 1:1 ratio isolation transformer.
When the secondary of a transformer is opened, there is no longer any load on the transformer. There will be some current flowing in the primary winding, which is needed to induce the voltage in the secondary. This primary current is referred to as the "no load" current, and is indicative of the core losses in the transformer.