Want this question answered?
Camshaft bearing caps.......215 in lbs
The camshaft position sensor on a 2002 Mitsubishi Gallant is located behind the rear camshaft bearing. It constantly updates the vehicle' computer about the status of the camshaft.
no but you can make bushing for it
The camshaft position sensor on a 1998 Pontiac Grand Prix is located behind the rear bearing of the camshaft. It constantly monitors the rotation of the camshaft and relays this information to the computer.
The camshaft sensor on a 1993 Pontiac Grand Am is located behind the rear bearing cap. It detects the position of the camshaft as it rotates and relays this information to the computer.
The camshaft sensor on a 2001 Chevrolet Venture is located behind the rear bearing cap. It monitors the rotation of the camshaft and updates the computer constantly.
The camshaft position sensor on a 1991 Acura Legend is located at the back of the camshaft, near the rear bearing cap. It monitors the rotation of the camshaft and relays this information to the vehicle's computer.
Friction, wear, and finally a breakdown.
You either need a camshaft bearing installer/remover. Or just take the block to your local machine shop..
in the 1994 3e-e engine the camshaft bearing cap torque is : 10 Ft-lbf Hope it works for ya!
A camshaft is driven by a linkage from the crankshaft, and operates your valves; directly in an OHC setup, and via pushrods otherwise. Cam "follower" is just an updated "roller bearing" for a camshaft.
Engine code 176A7.000 camshaft carrier/cap torques M8x1.25 = 20Nm M8 = 10Nm