This sounds like an idle problem. Does the service engine light come on before the engine stalls? If it does it should post a code. Knowing what that code is could lead to a more accurate assessment of the problem. Does the engine idle ok before you put the car in gear? Does the engine restart and idle ok after the stall?
There are multiple possible causes for the stall. The IAC, idle air controller, could simply be dirty and not delivering enough air for the engine to run. If the MAF, mass air flow sensor, if faulty or dirty that might cause the engine to stall. If the Oxygen sensor is faulty that could cause a stall and generally poor running as well. It may be possible that if the TPS, throttle position sensor, is faulty that could cause the engine to stall at idle speed.
If you have found out what the problem is I would be interested to know for future reference.
1982
Low or no freon will cause the AC not to work. Also if the clutch on the AC compressor has failed, or if the compressor itself failed.
To remove the ignition switch on a Chevy Celebrity: 1. Remove the trim panel below the steering column. 2. Remove the 4 bolts that hold the steering column up. If it has column shift remove the shift indicator cable. 3. Unlatch the wiring harness connector and remove it. 4, Take out the two screws and the switch will come off. If you are replacing the switch follow the instructions that come with a new switch.
If the check engine light has come on, have the codes read. That would be a good place to start.
Remove the inside door panel of your 1987 Chevy. Remove the linkage from the door handle. Remove the door handle retaining bolts. The door handle will come off.
Anything before 1987.
I'm not trying to stall you, I'm just trying to come up with a perfect sentence for stall. The mare is in the stall.
Celebrity Come Dine with Me - Ireland - was created in 2012.
The ECU may be creating a short circuit. Check the ECU on the 1987 Chevy Blazer and make sure it is expelling to correct amount of safe voltage. If not the computer should be replaced.
If the torque converter does not unlock, the engine will stall.
Check your EGR valve Check EGR valve
Yes, you should take out the rear panel in the trunk. After you have the inner rear panel off just remove the 4 wing nuts at the corners, the light assy. will come right out. Two torque screws on the license plate sides of the lights. Wasting your time with the wingnuts.