besides burning yourself, the antifreeze can burn you too. But never try and undo headbolts on a dead cold engine either if you can help it. Room temperature is best to 100 degrees. Bolts can really seize at low temps and besides burning yourself good i know of know other reason .
No you will burn your self
No machining is advisable when material to be machined is red hot rather it can be forged, extruded. Primary machining only is normally advisable when material is red hot.
It,s circulated there from the hot engine block and cylinder head by the pipes, hoses and the engines water pump. It could be up to 230 deg F
No, it is not advisable to use hot oil on your hair after the keratin treatment.
When you want something heated not too hot.
About 2-3 hours labour involved. Figure out from your local plumbing rates.
hot head
It could be a head gasket or a cracked head. Look at the exhaust manifold for each cylinder on the side that has the white smoke, the cylinder that has the leak will cause that port on the manifold to get super hot. One way to quickly identify which port is to spray some cheap black (or color of choice) paint on the exhaust manifold and fill the radiator and start the engine. The paint on the bad cylinder will burn off first.
This is to allow for expansion of the hot water-- otherwise the cylinder would blow up.
Yes, but it's not advisable unless you have the skills.
You can fix your 1985 Chevy Corvette by replacing the thermostat. If the automobile still runs hot, you might need to replace the cylinder head gasket.
Sounds like you have a blown head gasket. If you get white smoke out through the exhaust, you may also have a cracked cylinder head.