answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Why lube oil level decreasing in gas turbine bearing was damage?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Engineering

What is fore bearing in civil engineering?

In survey when take level of spot in forward direction is forward bearing opposite to back bearing which if back direction


The gross head in turbine installation is difference of level between?

it is difference between the water level from head race and tail race


How many watts does an eighty foot tall wind turbine produce?

The height of a wind turbine has no impact on the turbine's output wattage. The factors that effect the watts produced are: * The efficiency of turbine design (this is at most 59%) * the density of the air * the radius of the turbine (that is, the length of each fin) * the velocity of the wind passing through the turbine An 80 ft tall turbine would presumably have a fin length (that is, turbine radius) of at most 30 ft. Thus, at sea level on a 59 degree (F) day, in an 8 m/s (18mi/h) wind, with the most efficient turbine design possible, you would generate approximately 15.4 Kilowatts. See: http://en.wikipedia.org/wiki/Wind_turbine#Potential_turbine_power


What will happen when boiler steam drum level goes down?

Overheating of water wall tubes may cause crack. Boiler will damage due to boiler drum level goes down.


What is the load bearing capacity of Graval?

The bearing capacity of gravel depends on it's level of compaction and also on the presence of pore water.*However the following presumed values for bearing capacity have been quoted in text books:A,+Compact gravel and compacted sandy gravel - 600 kPaMedium dense gravel and sandy gravel - 200-600 kPaLoose gravel and sandy loose gravel - 200 kPa.*NB These presumed bearing capacities are for footings with a width (B) greater than 1m and where the depth to the phreatic surface is greater than B below the base of the footing.+ There are a number of empirical formulations used in geotechnical engineering to calculate bearing capacity of footings on soils however they cannot be reproduced effectively here.A Cobb, F. (2009). Structural Engineer'sPocket Book. Second edition. Oxford, Butterworth-Heinemann.

Related questions

What is catenary of turbine?

Catenary is the curve formed by the Turbine Rotors when they are placed on their respective Bearings.The level of each bearing and its housings are ear marked or indicated by the manufacturer of turbines.At the time of erection this is to be followed by laser alignment or by piano wire,water level etc


How can you lower your?

Decreasing the level of sex hormones help to decrease libido.


Why deaerator is placed at a higher level than turbine?

Your question is very Bad should you know the dearator in water cycle and turbine in steam cycle


If you were traveling from Colorado to Mississippi would your elavation be increasing or decreasing?

Decreasing because the lowest elevation in Mississippi is 806 feet above sea level. The lowest elevation in Colorado is 3,315 feet above sea level.


How do you measure level of tank?

Steam Rate calculation Formula for Steam Turbine


What is fore bearing in civil engineering?

In survey when take level of spot in forward direction is forward bearing opposite to back bearing which if back direction


Which sequence shows a decreasing of level of complexity?

organism > organs > tissues > cells


Sequences shows a decreasing level of complexity?

organism > organs > tissues > cells


The gross head in turbine installation is difference of level between?

it is difference between the water level from head race and tail race


What is the theory behind generating electricity through hydroelectric power?

The main theory is that in a closed system, water at a high physical level runs downhill to a lower physical level. This water flow through the generators turbine blades induce the turbine to turn. Control of the water flow through the blades controls the speed of the turbine generator. The head pressure and volume of the water govern the size of the generator that is connected to the turbine.


You closed your gunite pool in the fall The water level is decreasing What may be the problem?

I am waiting for the answer.


What are the Causes of decreasing of groundwater level?

Wasting of water by people unnecessarily for their own uses..