answersLogoWhite
Air Conditioning and Coolant
Heater Cores and Blower Fans
Car Heaters

Why makes my AC turn warm at idle and cold when driving?

171819

Top Answer
User Avatar
Wiki User
Answered
2013-05-16 11:29:21
2013-05-16 11:29:21

Most likely cause is an inoperative condensor fan.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The Idle speed control serves a few functions such as increasing the idle when the vehicle is cold to keep it from stalling. It also responds to increased engine load such as when you turn on the air conditioning or turn the steering wheel at idle. Without the idle speed solenoid the vehicle would stall nearly every time you came to a stop.



To adjust the idle on Mazda 929 from 1992-1995.......on the top side off throttle body there is a idle air screw,turn screw cloclwise to reduce RPM. Question...is idle always high when hot or cold?


to turn on the high idle you must run a wire to the ecm /www.kennedydiesel.com:.webloc if you go to this link it will give you the instructions to do it. I did it on my truck and it works great !!! if you have a car starter with an available output you can connect it through that and run you high idle from that.


adjust the idle screw on the drivers side of the throttle body turn it to the right to lower you idle turn to the left to raise it


is this happening when car is at idle? the indicators use power so sometimes at idle the amp meter will fluctuate because of this. if this is happening when driving i would have alternator and battery checked


Turn the Idle Adjusting screw.


Hi there, there is no idle adjustment on this vehicle. The most probable cause is a leaking throttle body gasket, or a bad Idle air control. A stuck open thermostat will cause a high idle in cold climates. Good luck and let me know you find wrong.


Turning the lights on put a load on the alternator causing the idle speed to drop. I would have the battery and charging system tested to make sure everything is okay. The battery may be on its way out.


There is an idle screw on the side of the carb its the one you can turn by hand if you have to use a screw driver its probably not the idle screw. turn it CW to increase and ccw to decrease.


The idle on a Toro push mower can be adjusted by turning the screw located on the carburetor. Turn the screw to the right to gain idle speed and turn the screw to the left to diminish idle speed.


More than likely the Idle Air Control (IAC) is defective.


Your car may need power steering fluid if it makes a buzzing noise when you turn the wheel.


Idle speed is computer controlled and is not adjustable.


turn the idle screw on the throttle body




This depends if it is on a carbureator or on fuel-injection. On a carbureator, locate the idle adjustment screw and turn until idle is satisfactory.


There should be an idle setting on the side of the rochester carb.


With the engine running, turn the idle screw until you get the speed you want.


Turn the idle nob on the ecu counter clockwise a little until you get the idle you want.


yes, cold temperature causes the wick to freeze which in turn makes it harder for the wick and wax to burn.



You don't. The idle speed is determined by the on board computer and the idle speed control (ISC).


Turn the idle mixture screw in to lean the mixture, out to richen the mixture.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.