answersLogoWhite

0

Reverse saturation current of silicon is in nano ampear therefore it is prefered over germanium

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How does a multimeter read volts?

A multimeter reads volts by measuring the electrical potential difference between two points in a circuit. It does this by sending a small known current through the circuit and measuring the voltage drop that occurs. The multimeter then displays this voltage drop as the voltage value on its screen.


How to use a multimeter effectively for measuring electrical parameters?

To use a multimeter effectively for measuring electrical parameters, first select the appropriate setting for the parameter you want to measure (voltage, current, resistance). Next, connect the multimeter leads to the circuit or component being measured. Ensure the multimeter is set to the correct range and polarity. Finally, read the measurement displayed on the multimeter screen and record the value if needed.


What instrument measures peak to peak voltage?

All Moving Iron Type measuring instruments major rms value of quantities.


Does a standard multimeter measure ac in peak or peak to peak?

Neither. A.C. voltage, and current, are expressed as root-mean-square (rms) values, and this is what a voltmeter and an ammeter reading will indicate. To measure peak voltage, or peak-to-peak voltage, you will need to use an oscilloscope.


Why is the class A current less than the peak current?

Not sure what you mean by Class A current. Normally, when measuring AC voltage or current you either measure the peak to peak value or the Root Mean Squared (RMS) value. Since RMS is essentially an average measured over time, it would always be less than Peak to Peak value.


Who would calibrate a multimeter?

An electrician, it is an electronic measuring instrument


When measuring an unknown voltage with an analog VOM you should first?

For any value turn the multimeter to the highest scale in the value that you are measuring. By doing this you will not overload the meter by using a lower scale to measure a higher value.


Principle of multimeter?

Based on the principle of the D'Arsonval galvanometer, the main function of a multimeter is measuring a circuit's voltage, current, and resistance.


What is the procedure for measuring frequency in hertz using a multimeter?

To measure frequency in hertz using a multimeter, set the multimeter to the frequency measurement mode. Connect the multimeter's probes to the circuit or signal you want to measure. The multimeter will display the frequency in hertz on its screen.


What level of multimeter are you using?

A multimeter is an indicator for general measuring purposes. It usually not acurate enough to take measurement of hi precision.


What happens if the indication needle is not positioned to zero when measuring?

the multimeter is damage


What are the advantages of multimeter over other instruments?

A multimeter is far better for measuring electrical charges, resistance, etc then say a slide rule