Want this question answered?
If some solution splashes out during the titration of NaOH, the volume at the end point will be wrong.
It allows the concentration of the NaOH to be known.
the standard solution in the above titration is citric acid because out of citric acid and naoh only citric acid can be obtained in purest frem while naoh is hygroscopic in nature
Why all peoples are selfish
Methyl orange
You have to realise that a drop from the burette for instance is insignificant, if you are dealing with at least 10ml solution which you usually deal with on a titration. If you don't want to regard it as insignificant, then if NaOH is in the burette, then the solution doesn't become more concentrated with NaOH because that drop escaped.
If some solution splashes out during the titration of NaOH, the volume at the end point will be wrong.
It allows the concentration of the NaOH to be known.
This depends on the mass of NaOH dissolved in 1 L water.
the standard solution in the above titration is citric acid because out of citric acid and naoh only citric acid can be obtained in purest frem while naoh is hygroscopic in nature
Why all peoples are selfish
Methyl orange
Before a burette is used, it needs to be cleaned. During the cleaning process, usually, water is introduced into the burette. Be the water clean or not, if the burette is then used without rinsing it with the solution that it is going to be filled with, the result of that analytical exercise will not be precise and accurate. The reason is that water residue in the burette would dillute the solution when it's filled in the burette which would make it impossible to determine the exact concentration of the solution moved by the burette. By rinsing and re-rinsing the burette several times with the solution it is going to be filled with, residue water from the cleaning process would be successfully removed from the burette as are other leftover substances from the cleaning process. This practice is quite important as basic analytical technique.
discussion for the titration of NaOH and HNO3 by using phenolphthalein & methyl orange indicators
Yes you can use methyl red, methyl orange, bromophenol blue and other indicators instead of phenolphthalein in the acid-base titration of NaOH.
cuz' borax contain boric acid (H3BO3) which is very weak acid , thus it gives non accurate titration, so we add neutral glycerol to increase the acidity by the way we add glycerol after titration of NaOH not before
acid-base titration