oltc is situated on primary side of transformer because by primary side we can obtain fine voltage change by tapping with low current flow through it.
In general, you can install a wattmeter on the primary or the secondary side of a transformer (it depends what you are trying to measure). But if you are conducting an open- and short-circuit test (to find the transformer's losses), then the wattmeter is connected to the primary side because you want to measure the total (primary + secondary) losses and that is only achievable from the primary side.
The 'input' side of a transformer is called its 'primary' side, whereas the 'output' side is termed its 'secondary' side. The ratio of its secondary to primary voltage is equal to the ratio of the number of turns in the secondary windings to the number of turns in the primary winding. So if, for example, a transformer's secondary winding has twice as many turns as its primary winding, then the secondary winding will produce twice the voltage applied to the primary winding.
It's installed on the high-voltage side.
high voltage side call primary
Yes, but it's usual to have fuses on both sides of the transformer.
OLTC - INSTALLED IN THE PRIMARY SIDE OF A POWER TRANSFORMER TO SELECT OR ADJUST VOLTAGE. THE ADVANTAGE OF THIS IS FOR SOLVING THE VOLTAGE DROP ISSUES IN THE SECONDARY OUTPUT IN THE FARTHEST LOCATION. FOR EXAMPLE YOUR SECONDARY VOLTAGE REQUIREMENT IS 380 VOLTS AND YOU CAN ADJUST TO 400 VOLTS FOR LONG CABLE RUNS.
The heart is situated on the central side of the thoracic cavity
Dorsal is situated on the upper part and at the rear of a body, lateral is situated at the side
The liver is situated on the right side of the abdomen just below the ribs and the diaphragm which separates the chest and the abdomen
the Indian ocean
A house composed of 2 side by side apartments is called a duplex.
Geographically, Redbridge is situated in northeast London.
Primary is the main thing that happens. The side effect is what happens because of the Primary thing.
The horn is situated at the front of the engine compartment. The horn will be to the left of the drivers side headlight assembly.
This isn't the case. You can have aluminium or copper on primary or secondary side of a transformer.
It is in the trunk, situated on the right hand side.
In general, you can install a wattmeter on the primary or the secondary side of a transformer (it depends what you are trying to measure). But if you are conducting an open- and short-circuit test (to find the transformer's losses), then the wattmeter is connected to the primary side because you want to measure the total (primary + secondary) losses and that is only achievable from the primary side.