0
Why one does removes the plastic coating of connecting wires before making circuits?
Because they'll be joined with a connector of some sort (I work in automotive, so it's usually butt connectors). Inside that connector will be metal which will help transfer electrical energy from one wire end to the wire end of the one it's being connected to... plastic is an insulator, and if it's left there, it'll inhibit the flow of electricity.
What else can I help you with?
Why do you need to sand paper metals?
Sanding metal creates a smooth surface, removes imperfections, and prepares the metal for painting, coating, or adhesion of other materials like solder or glue. It improves the appearance and adhesion of finishes on metal surfaces.
What removes sand and other sediment from ground?
Wind removes sand and sediment from the ground in a process called deflation.
What removes sand other sediment from ground?
Wind removes sand and sediment from the ground in a process called deflation.
What removes rust from toilet bowls?
BLEACH
What removes carbon dioxide from the bloodstream?
lungs .
What kind of doctor removes fat?
Plastic surgeon
What removes acrylic paint from plastic surfaces?
Acetone or rubbing alcohol can effectively remove acrylic paint from plastic surfaces.
What is a downward pushing force that rapidly removes air from a plastic bottle?
Adding magnesium powder
Why should the negative terminal be removed before working on near instruments and electronic circuits?
Static electricity may build up and discharge through the circuits you are working on. This may damage them. Removing the ground cable, removes the discharge path to ground.
Does parboiling help keep eggs fresh?
No, actually eggs will stay fresh longer if they are refrigerated and left raw. There is a coating on the shell that protects them. Boiling removes this protection.
Why do you need to sand paper metals?
Sanding metal creates a smooth surface, removes imperfections, and prepares the metal for painting, coating, or adhesion of other materials like solder or glue. It improves the appearance and adhesion of finishes on metal surfaces.
How do you reset the maint req light in your 94 mighty max?
It is located in the right side of the gauges of the dash it has a small pop out plastic rectangle that removes with a small flat screw driver
How do you clean a jetta headlight cover?
On my 2001 Jetta 1.8T, the outside of the plastic headlight housing gets yellow, probably due to UV light. I use Mother's Mag & Aluminum Polish, which removes the very thin layer of plastic (probably less than 0.001") that has yellowed.
What goes on in the tv when you turn it off?
The television has internal electronic circuits which supply established voltage to the essential parts of television, and when switching off, the main supply power from a supply lead through to the television is isolated at the off switch which removes the voltage to the power supply circuits, this voltage supplied by the stabilising circuits the diminishes to practically zero quite soon. With no voltage supplied by these supply circuits the main operating functions cease, but a certain amount of charge is still left within the electronic circuit so this is discharged through the same operating circuits in the form of a small amount of heat. Which is what happens normally anyway. This amount of heat is reflected in the power consumption, and carries on until the voltage supplied is actually zero, and hence no voltage is present to charge the circuits, and now could be classed as safely switched off. The voltage would have been described as having being discharged through the load of the circuits.
What type of chemical in a class a fire extinguisher?
water - removes heatsodium bicarbonate - dry chemical, removes oxygenhalons - dense gas, removes oxygencarbon dioxide - removes heat and oxygenetc.
What system removes waste from animals?
The excretory system removes waste from the body's metabolism and the digestive system removes waste from the body
Why does the penny turn silver in color when cooked in sodium?
When a penny is cooked in sodium, a reaction occurs that removes the copper coating from the penny. This leaves behind a layer of silver-colored elemental sodium on the surface of the penny, giving it a silver appearance.
