The output of a common emitter stage is inverted, it is not out of phase.
54.6dB
Common emitter is the only transistor configuration that has an 180 degree phase difference between input and output. Common base and common collector outputs are in phase with the input.***********************************That is incorrect.The output of the common emitter is inverted, there is no phase shift.
altough voltage follower circuit provides output voltage which is in phase to input voltage as in noninverting amplifier but in unamplified form.
Input offset voltage is the equivalent voltage at the input of an operational amplifier. If an amplifier has a voltage gain of ten and an input offset voltage of 10 microvolts, a level of 100 microvolts will appear at the output with no input. Manufacturers try to design an op amp so the input offset voltage is as small as possible to minimize this error voltage at the output of the amplifier, especially for applications where small voltages are being amplified.
That depends on both the input signal and the type of amplifier the transistor is used in.
Since we know that the amplifier gain is given by A=Output voltage/input voltage (where A is the amplifier gain) So, it can be written as output voltage=A*input voltage, so when the output part increases gain increases but when input part increases gain decreases
Voltage gain is the ratio of the output voltage of an amplifier to its input voltage.
In Voltage Shunt Amplifier, the Output voltage is supplied in parallel with the Input voltage through the feedback network.
An inverting amplifier is one where the output is an inverted function of the input. The Class A transistor amplifier, also known as common-emitter, is inverting. As you increase the voltage on the base, the output voltage on the collector decreases. The operational amplifier has an inverting and a non-inverting input. In typical bridge mode, the output is inverted with respect to the (inverting) input, and the non-inverting input is used to reject common-mode input signals by moving the virtual ground point as needed.
The amplifier whose output is inphase with it input means if we consider voltage amplification then there is zero phase shift in input and output
In common emitter amplifier circuit, input and output voltage are out of phase. When input voltage is increased then ib is increased, ic also increases so voltage drop across Rc is increased. However, increase in voltage across RC is in opposite sense. So, the phase difference between the input and the output voltages is 180 degrees.
54.6dB
Common emitter is the only transistor configuration that has an 180 degree phase difference between input and output. Common base and common collector outputs are in phase with the input.***********************************That is incorrect.The output of the common emitter is inverted, there is no phase shift.
A common base NPN amplifier is used for high frequency applications as the base minimize oscillations at high frequency, separates the input and output. In a common base NPN amplifier the voltage gain is high, relatively low input impedance and high output impedance compared to the common collector.
output resistance decreases and input resistance increases
altough voltage follower circuit provides output voltage which is in phase to input voltage as in noninverting amplifier but in unamplified form.
altough voltage follower circuit provides output voltage which is in phase to input voltage as in noninverting amplifier but in unamplified form.