A common base NPN amplifier is used for high frequency applications as the base minimize oscillations at high frequency, separates the input and output. In a common base NPN amplifier the voltage gain is high, relatively low input impedance and high output impedance compared to the common collector.
The average amplifier is 60 to 200 amps.
The horizontal and vertical amplifier in the cathode-ray oscilloscope are deflection plates. The horizontal amplifier causes the beam to be deflected horizontally at a rate that is uniform. The vertical amplifier causes the beam to deflect vertically.
the first amplifier was made in the year 1909. this was the audio amplifier of vacuum tube type.
A microphone is usually connected to an amplifier.
input. The microphone gives a signal to the computer/radio/whatever you're using. it is input because when you speak into it,it gets in the amplifier and the amplifier processes it to came out as sound through the speaker
You can use an npn or a pnp bjt in a common emitter amplifier circuit. The decision of which one to use is based on whether you want the collector and base to be more positive (npn) or more negative (pnp) than the emitter.
result of output characteristics of npn transister in CB mode
With a common emitter amplifier it's the emitter that is usually grounded.
In an NPN transistor an emiter follower refers to an amplifier topology. The emiter follower configuration is when the emitter of a N-Type Bipolar Junction Transistor (BJT) is connected to the common point on a circuit (typically ground). This is not always the case, however, because many amplifier configuration exist.
A: It always a voltage since it is a voltage amplifier
3Db
as voltage amplifiercurrent followeri am yoges
A sexy transistor are two type. NPN and PNP..... c means common b means base .
holes are majority in base
A PNP transistor has no advantage or disadvantage over an NPN transistor in its ability as an amplifier. Rather, the current-handling capacities of the transistor determine if it's usable as an amplifier.
To know if a transistor is PNP or an NPN,the following should be verified:For a PNP transistor, the base-collector junction is forward biased while the base-emitter junction is reversed biased.For an NPN transistor, the base-emitter junction is forward biased while the base -collector junction is reversed biased.
no, the emitter base junction should be foward for both npn and pnp to act as amplifiers.