A microphone is usually connected to an amplifier.
joystick and microphone
condenser is more detailed for sound
It is a light-weight device that connects to the microphone or microphone stand. It is used to shield the microphone from any ambient noises in the surroundings.
No. You will have to use an external microphone.
The microphone. Because it is the gateway to your recording, your recording can be only as good as your microphone allows. While both are important, it is possible to get a good recording from a great microphone and poor recording unit, but the best recording unit can make only a poor recording from a poor microphone.
A microphone is usually connected to an amplifier.
Typical microphone has no volume adjustment, it can be adjusted in electronic device where microphone is connected.
It's simple! All you need is to have a microphone and a control pad both connected to the console!
It is amplifying her voice. If the microphone is connected to a computer, it could be recording or relaying her voice in a digital format.
Yes. Any microphone or gaming headset that can be connected to your computer can be used.
Make sure your microphone is connected properly and working right. Sometimes loose connections will prevent you from using the microphone to record.
Yes if you have a microphone connected.
You cannot connect a USB microphone to a mixer. It must be connected to a computer. The Behringer 502 can accept any dynamic or condenser microphone with an XLR connector .
A microphone connected to an amplifier and speaker(s).
Many words are related to microphone. Examples are:button microphone,capacitor microphone,carbon microphone,condenser microphone,contact microphone,dictaphone,digital microphone,dynamic microphone,electrostatic microphone,hydrophone,laser microphone,lavalier microphone,liquid microphone,mic, mike,moving coil microphone,omnidirectional microphone,parabolic microphone,pick-up,piezoelectric microphone,ribbon microphone,shotgun microphone, tap,throat microphone,unidirectional microphone,water microphone,wire-tap, wire-tapping,wireless microphone
You don't need a mixer. You will need an audio interface (either USB or Firewire) that has phantom power, that is, 48 volt power to power this condener microphone. With the interface connected, you can use this microphone with Garageband or any other recording software that support CoreAudio hardware.
Microphones are connected to input devices that read the voltage from them and hence are not driven to make noise. If you connect a power source to a magnetic or crystal microphone you can get some noise but not much. The speaker is very small and not designed for produciing sound Many microphones are dynamic and use capacitance. Hence you can not drive them like a magnetic microphone. Note: you can use a speaker as a microphone.