Beacause CT is shorted so it is kept opened
In DC inductor is short circuited .
Transformers (2007)Transformers: Revenge of the Fallen (2009)Transformers: Dark of the Moon (2011)Transformers: Age of Extinction (2014)Transformers 5 (2017)
Transformers (2007) , Transformers: Revenge of the Fallen (2009) and Transformers: Dark of the Moon (2011) .
Transformers (2007)Transformers: Revenge of the Fallen (2009)Transformers: Dark of the Moon (2011)There may be another Transformers movie in 2014, according to an interview with Tyrese Gibson.
"Transformers" was produced by Dreamworks .
Current transformers (CTs) -together with voltage (or potential) transformers- are 'instrument transformers'. CTs are used to enable large currents flowing in high-voltage systems to be measured, while electrically-isolating the ammeter (termed a 'burden') from the h.v. system. They are also used to monitor h.v. currents for high-voltage protection systems. Before disconnecting its burden, the secondary of a CT must be short-circuited, and remain short-circuited until after the burden has been replaced. This is because a dangerously-high voltage will appear across the open terminals of any energised CT.
The difference between current transformer and potential transformer is that the secondary of a current transformer can not be open circuited while under service whereas that of the potential transformer an be open circuited without any damage to the transformer.
A current transformer's secondary must never be open-circuited. If the instrument fed by a CT needs to be removed, then the secondary terminals must be short-circuited first. This is because a large, and potentially-dangerous, secondary voltage will appear across an open-circuited CT. Normally, a set of links is provided at those terminals for this purpose.
Prove that capcitor will be open circuited if DC source is applied?
Current transformers produce a ratio of primary current in the secondary. If the secondary of a CT is open circuited, and primary current is flowing, the CT will try to push that same ratio of current through the secondary open circuit. This causes secondary voltage to climb until it the secondary open circuit flashes over. This can often damage the CT.
depletion layer surrounding the junction where electrons from N side have fallen into holes from P side.
By direct from the manufacturer! Current & Potential Transformers
PTs are high voltage, low current transformers and so need a relatively high impedance (or burden) load to function accurately. CTs are high current, low voltage (if not open circuited!) transformers and so need a very low impedance load to function accurately.
find a decepticon
In DC inductor is short circuited .
Dirt, moisture and overheat
Its secondary must never be open circuited. If its burden is to be removed, then the secondary must be short circuited first, and removed only after the burden is replaced.