The idea is based avoiding use of the thermometer when it is reading "higher" than what it is that is being measured. Let's look at what's happening. If we wash a clinical thermometer in hot water, it will respond to that hot water. That will cause the reading to shoot up well above a hundred degrees. If we then try to use it, it will have to "cool down" under the tongue of the person we're using it on. It is actually being cooled by that person. The thermometer will take a relatively long time to reach the temperature of the individual whose temperature is being measured. And this time will vary, but will be longer than it would be for the thermometer to "come up" to temperature. One of the directions for using these thermometers is to first shake it down until it reads less than 95 degrees or so. If you're starting with a thermometer than has just been washed in hot water, you're not going to be able to shake it down per the directions. You'll have to run it under cool water for a bit to cool it so you can use it.
becuse alla does it
if its really really hot it will fry but if its just hot then it will just go up really high
One of the problems with water in a thermometer is the effect of capillary action - the column of water tends to "stick" to the sides of the thermometer and create a U-shaped surface at the top. This makes it very difficult to read the thermometer. Previously mercury was considered to be a good medium for thermometers, but this has been discontinued due to the health risks from a broken mercury thermometer; the current medium in thermometers is dyed ethanol or methanol.
That depends on how hot the water is in the cup. Use the thermometer to measure it and see.
please study your lesson and listen to your teacher when she/he is teaching....dont chatwith your friend whille teaching so that you dont need to research understandddddddddddddddddd
Because clinical thermometer have a very small range. (20 to 45 degrees Celsius at most) and if placed in boiling water, the water being 100 degrees will cause damage to the thermometer.
A clinical thermometer is used to measure a human body, and the laboratory thermometer is used to boil water and other lab uses.
No.
becuse alla does it
cotton should be washed with cold water
if its really really hot it will fry but if its just hot then it will just go up really high
Boiling is way far outside its operating range.
Rinse them with water and you're good!
When calibrating any kind of thermometer in an ice water bath, the temperature should be 0o C or 32o F.
Because it will bust.
the mercury should be at normal body temperature level before using it the thermometer should be cleaned after use with normal water the bulb of the thermometer should not be touched
Place it in ice water. It should read 32°.