dc motors can be operated at no load as well as at load condition.But by using the swin burns test the efficiency can be calculated at no load which is more benficial than load test.At industries this swin burns test is used because for load test we have to give separate supply for the load to run.In no load test that power is saved.
well, at no load its doing no work and thus serves no purpose
See Aerobicle on Youtube.It's about 20 inches.
dc series motor :A series-wound DC motor has a low resistance field and armature circuit. Because of this, when voltage is applied to it, the current is high. (Ohms Law: current = voltage/resistance). The advantage of high current is that the magnetic fields inside the motor are strong, producing high torque (turning force), so it is ideal for starting a train. The disadvantage is that the current flowing into the motor has to be limited, otherwise the supply could be overloaded and/or the motor and its cabling could be damaged.
Well, it depends on what you want. If you want a netbook~ i reccommend the HP Mini 110 series or the HP Mini 210 series. The 210 series got better reviews than the 110 series, but it is your choice. If you want a laptop, i recommend anything. bi bi now
Yes, like the dynamo on a bicycle that provides power for the light, instead it can run an electric motor with the help of a few cheap diodes(Bridge diode setup)
A centrifugal motor is a motor that David Unaipon invented for his people but couldn't be created because he doesn't have enough money
It develops a large torque and can be operated at low speed. It is a motor that is well suited for starting heavy loads..
The blower should be operated a few minutes before you start the motor to vent gas fumes from engine compartment.
The blower should be operated a few minutes before you start the motor to vent gas fumes from engine compartment.
The blower should be operated a few minutes before you start the motor to vent gas fumes from engine compartment.
Series DC motor develops a very large amount of turning force called torque from standstill and can be operated by using either an AC or DC power source.
If a DC series motor is started without load, the armature winding (winding that doesn't spin) current will be at a minimum, resulting in the motor going to maximum speed / runaway, which can cause things to fly apart. As Armature current increases, the speed of the motor will decrease. The armature current will be forced to increase / speed of the motor will be forced to decrease as more and more load is applied.
what is the function of motor device
Battery Operated Motor
In dc motors Speed is directly proportional to back emf and inversely proportional to flux i.e N∝(Eb/φ) In series motor back emf is practically constant. So if we start motor without any load Flux will be small and so speed will be very high. if we start motor without any load it will gain very high speed and may get damaged due to centrifugal forces. Series motor have very high starting torque and used where high starting torque is required.
At no load, the flux is only due to the residual flux, which is very small. the no load speed of dc series motor is very high. so the rotating part of the motor are damaged. hince dc series motor should never be run without motor.
spin the motor, if its raspy or rough, any play in it, replace it! i should have done that first! i went through 2 resistors. im bummed!
lawn mower