0
fnmffdiddnvidvf
Anonymous
Heating a magnet can cause it to lose its magnetic properties, while hammering or dropping it can disrupt its internal structure leading to a decrease in magnetic strength. It is best to handle magnets gently to avoid damaging them and ensure they maintain their magnetic properties.
Add your answer:
Earn +20 pts
What is the care and storage of magnets?
Magnets should be stored in a cool, dry place away from heat sources and other magnets to prevent them from losing their magnetic properties. Care should be taken to avoid dropping or subjecting magnets to impacts, as this can weaken or damage them. When not in use, magnets should be kept separate from each other or stored with a non-magnetic material between them to prevent them from sticking together.
Is it safe to reuse microwave magnets?
It is not safe to reuse microwave magnets because they may have wear and tear that affects their safety and performance. Additionally, microwave magnets can be a source of radiation and should be handled and disposed of properly.
Jack tries to place magnets on his refrigerator at home but they won and rsquot stick. What could be the reason?
The surface of the refrigerator may not be magnetic, or the magnets may not be strong enough to stick to it. Jack should try using stronger magnets or placing the magnets on a different magnetic surface to see if they stick.
Can too many fridge magnets cause damage?
No, having too many fridge magnets should not cause damage to your refrigerator. However, having excessive magnets can make it harder for the door to close properly, potentially leading to energy loss or potential damage to the door seal.
Where are temporary magnets used?
Temporary magnets are used in various applications, such as in electronics, rubbing magnets for magnetic therapy, and in temporary holding devices for securing objects. They are particularly useful in situations where a magnet is needed temporarily and can be easily magnetized and demagnetized as needed.
Maganets shoud not be heated or hammered Why?
Magnets should not be heated or hammered because it disturbs alignment
Can you bring magnets on an airplane?
Small magnets should be fine, industrial strength magnets may cause problems in the cockpit
What stops the pulling power of magnets?
I dont think you can ---- If you super-heat the magnets, it will demagnetize them, thus stopping the "pulling power" of the magnets. Basically stick the magnets in a vat of super boiling water, that should be sufficient enough heat to demagnetize the magnets.
Should the bomb be dropped or should it not have been dropped?
Most people beleive the decision was right.
Is big magnets stronger than small magnets?
No.You should find how much it can attract other things.
What is observed when zinc nitrate is heated?
it should be heated at 500°c
Why should deodrant not be heated?
deodorant should not be heated because all the particles inside don\'t have the strength to get heated because of all the heat that\'s added to it.
How are rusty magnets and regular magnets alike and different?
Well, they are both magnets for starters. Depending on their sizes, they should have a similar amount of magnetic strength. Rey are different because a rusty magnet isn't as powerful as a normal magnet, but they should both work.
How many pools are heated in the US?
How many should have been electrically heated.
Why should cans not be heated on a stove?
Unopened can will explode if heated directly on a stove.
Are advertising magnets for your car safe for the paint?
Advertising magnets are generally safe for your vehicles paint as long as care is taken while displaying them. You should try to limit moving the magnets while they are attached to avoid scratching the paint in any way. Care should also be taken when applying and removing the magnets this should be done often to clean any residual dirt and grime build up from around the magnets and on your car. With the proper care steps being followed advertising magnets shouldn't pose a hazard to your car's paint job.
How do you align magnets in a maglev model?
I never tried it, but the magnets on the maglev should face opposite to the magnets on the track. If u face north downwards in the maglev, then u'll have to face the north upwards in the track.
