The high power is because so you can see it u close and the low power is further away.
You shouldn't. You can cause the high objective to smash into the surface of the slide and crack it. Always use the fine adj. for high power and if you cannot get the high power in focus, reverse out to low again and do it over. Ideally, if you are in focus on low, you should be in focus at medium (may have to adjust a small amount) and if you are in focus under medium, when you swing the high power obj. into place, it should be in focus as well (may need a fine tune). Always reverse out and start all over again if you cannot focus it under high power. Deja Was Here
use the fine adjustment knob to get a better view of what you are looking at.For low power you can use the coarse adjustment and fine adjustmentfor high power you should only use the fine adjustment because on high power, the objective lens is too close to the slide and using the coarse adjustment may scratch the objective lens.
No it does not
No.
using the course adjustment to focus the specimen under high power
Examine with high power magnification.
You should examine your cheeks in the mirror.
You shouldn't. You can cause the high objective to smash into the surface of the slide and crack it. Always use the fine adj. for high power and if you cannot get the high power in focus, reverse out to low again and do it over. Ideally, if you are in focus on low, you should be in focus at medium (may have to adjust a small amount) and if you are in focus under medium, when you swing the high power obj. into place, it should be in focus as well (may need a fine tune). Always reverse out and start all over again if you cannot focus it under high power. Deja Was Here
I believe it's the coarse adjustment.
Fine Adjustment knob
the same way as under low-power on a microscope: carefully
The coarse adjustment knob should never be used when viewing in high power with a compound microscope. When in high power, use the coarse adjustment (the knob smaller than the coarse adj.) to more accurately focus on the subject.
use the fine adjustment knob to get a better view of what you are looking at.For low power you can use the coarse adjustment and fine adjustmentfor high power you should only use the fine adjustment because on high power, the objective lens is too close to the slide and using the coarse adjustment may scratch the objective lens.
You can see less under high power because it focuses on a smaller part of the specimen, but in more detail than low power.
No it does not
No.
For low power you can use the coarse adjustment and fine adjustment for high power you should only use the fine adjustment because on high power, the objective lens is too close to the slide and using the coarse adjustment may scratch the objective lens.