The reason one should stop heating the solution before the liquid has completely evaporated is because heat will continue to carry over even after it is removed from the flame. This means that the liquid will continue to evaporate for a little longer.
It is essential that smears air-dry before heating. This is so that they do not move around and cause errors in observation.
This depends on what kind of solution you are about to titrate.
1. The advantage in diluting the solution before titration is that it allows for greater accuracy in the titration; this is because the color change in the solution is easier to observe if it is a dilute solution.
The water would have evaporated long before the temperature reached 374 degrees.
it is primary standard........ but before making solution dry it at 120. C
Be certain that the surface dew / moisture has completely evaporated before applying.
well i THINK heating the solution will speed up the reaction in the solution before adding the precipitate since the final observation required is the precipitation. you dont add the reagent before heating since it may give a false observation after heating, it might not precipitate normally but since you've otherwise it might. BY : RAY LEE SEACREST
No, heating glassware that is partially wet can cause danger as it would crack and explode.
Beakers that will be used to collect solutions should be completely dry before use due the possibility of water being able to dilute the solution that will be placed inside of the beaker. If a beaker is not completely dry before collection of a solution, an inacurracy in data results may occur.
The evaporated water from salt water has a lower density.
Slight heating helps in fixing the cells on to the surface of the glass slide
You heat water before you mix it because it increases the amount of solute that can be saturated into the solution.
before
0.230 L X 0.276M CaCl2 = 0.0635 moles CaCl2 present in solution.Moles before dilution = moles after dilution0.0635 moles/V = 1.10 M CaCl2.V = 0.0577 L left in solution.0.230 L (original) - 0.0577 L (left over) = 0.172 L (evaporated)0.172 L = 172 mL
your scene of touch can help you tell how hot or cold an object is.
Copper Sulphate crystals before heating r blue....but after heating I dunno , may be u should try and ask your Sci.Miss/Sir I'll get back when I get the other answer .
It is essential that smears air-dry before heating. This is so that they do not move around and cause errors in observation.