Bad ignition switch?
check ignition
I searched the internet and found Running time: 07:47.
There is no such position in baseball. The running back position is used in American football.
Hey E==The running lights have a module which may be bad. Good luckJoe
The "bulb check" feature of most cars work by all coming on momentarily as the key is turned to the "on" position before turning further to the start position, then go out if there are no problems after engine is started and running. Also on the "Check Engine" light will illuminate any time the key is in the "run" position but the engine is not running.
it could be of running it with out oil.
When you first turn on a motor it is starting from a static position and more current is required to get the motor up to speed (Starting current) than to keep it running (running current). Since watts equals amps times voltage you can see the difference in wattage is related to current. If you look at watts as work being done it is obvious that it requires more work to get the motor running than to keep it running.
Is fan set to the "on " position instead of "auto" position ???
turn the key from the off position to the on position without starting the car 3 times, finishing with the key in the on position but without the engine running. this enables the check engine light to display any engine fault codes.
Marshawn Lynch Is the starting running back for Buffalo
Turn on the A/C and then turn the ignition to the on position without starting the engine. The fan will be running if it is good.
if it starts and stays running you only have to do that to get it cranked its the tps throttle position sensor i had the same thing happen to me