Want this question answered?
AC and DC
Electricity is either alternating current or direct current, abbreviated AC or DC. An AC/DC Capacitor can be used in either an AC or DC current.
Power is as easy as PIE (P=IxE). Watts equals the current squared time the resistance. Assuming a pure resistive load; they are equal. To answer the question precisely, one DC watt equals one AC watt.
in Australia most homes are single phase 240 volts but when measured with a multi meter sometimes you get readings of between 230 and 250 volts
Alternating (AC) and direct (DC) currents are different forms of electricity. It is universal nowadays to have AC in all houses because the electricity grid distribution system is all AC. DC was used by Edison and continued for some years but is now discontinued. It is still used in vehicles where 12 V DC is the normal system. A light switch simply interrupts the current or makes the circuit as required, and both AC and DC need to have switches.
A ac tach usually works off the AC signal of the alternator on a bus or truck. The alternator produces AC power that is rectified to make DC current to run the car, truck or bus. There is a TACH terminal or in North American buses more than 10 years old it is called a stator tap. The AC voltage changes speed (frequency) with the engine and the Tachometer reads that as a signal Early or inexpensive ones are actually run on the AC current.
With a DC motor, power is supplied from a controller and transmitted to the motor windings via brushes and a commutator using pulse width modulation. This requires that the controller be adequate to handle the power/heat of the application and that the brushes and commutator are well maintained as they are wearing parts. With an AC servomotor, the controller only provides a low power signal to any size motor. Raw power to the motor is handled separately from the control circuit. The control signal is used to control the position of the motor which has internal position sensing capability. Power to the AC servo is always on.
AC servomotors require an alternating current as a power source, meaning they need to be plugged into an outlet, while DC servomotors require a direct current as a power source, meaning they can be run off of battery power.
A: It is a regular DC voltmeter but the AC is rectified and the DC component is measured and displayed as AC VOLTS.
It's measured with an AC voltmeter.
Typical VOMs can measure both AC and DC.
AC and DC
An engine usually has a higher idle speed when the ac is running. If the high speed idle does not operate then the ac will cause the engine to stall.
assuming this is Home AC question - speed up the AC fan speed
Its the fuse and if not its the fuse Boxs. by the cluch or brake peddle.
The opposition of current flow is measured in ohms. For DC circuits it is resistance and for AC circuits it is impedance.
It is done to control the speed of the motor.