Want this question answered?
To control a light with a switch, the switch has to be connected in series with the light fixture.
If you refer to a flurecent tube you need to check the starter if it has one (small round tube in the side of the light), check the fuse box for that light, check the switch for that light and check that the tube youve banged about has not also blown i.e. check in another tube socket if possible
if light is not going off, bad switch or short in wiring to light!!
That depends on your meaning. Are you talking about turning off the breaker when you screw in a new lightbulb or fluorescent tube? That isn't necessary, but it is a good idea to turn off the switch. If you're talking about installing a new light fixture, yes, you should always turn off the breaker or remove the fuse. Many electricians, if they are sure of what they're doing, will simply make certain that the light switch is turned off.
Always cheaper to switch it off and on rather than leaving it on.
To check the hold light blinking of a Mazda Protege, take off the plastic over the shifter tube or bar. Then take off the console below it and look at the wires that come up from the hollow center of the tube. The edge of the shifter tube may have cut through the wire insulation.
If your theft light keeps blinking while driving, chances are you have accidentally hit the toggle switch underneath the dash. Find the toggle switch that is located near the panel and click off the button.
what does it mean if my brake light is blinking on and off when its pushed down in my 1999 Chevy silverado
If you turn on your 1999 mustang v6 car and the right signal light stays on and doesn't blink and you switch the car off and then the left signal light stays on without blinking, then you need to see a mechanic.
It is blinking by a lamp first turning on, then turning off, then turning on, then turning off...
You pay for what you use. If the light is left on then it is costing you.
depends on what car you got it ussaly is a passenger air bag switch to turn on or off
The security light will blink when either door, hatch, or hood is opened and will continue blinking until it is closed. Check all 4 switches for proper operation. If the bad switch is disconnected it should turn off the light. If the security light is on constantly instead of blinking that is to let you know that the alarm system is activated and should turn off after a few minutes.
When the overdrive off light is blinking that means a malfunction has been detected
Yes, the blinking securtity light will blink when the car is off.
(this should be a grammar question) Switch off the light(s).
Is this condition only present when driving . If so it sounds like you have a faulty door switch .