0
Token ring is a loacal area network technology. It is limited in ldistance by its physical layer connection requirements.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What are the various topology of WAN and what is the drawback in BUS topology?
there are a few different topologies when you are talking about WAN's but remember WAN's topologies are different than LAN's because of the area they cover. But there are bus wan, ring wan, star wan, full mesh wan, partial mesh wan, and tiered wan. as far as a drawback to bus topology is that each site in the wan bus topolgy depends on every other site in the network to transmit and receive its traffic.
What wan topologies that are good choices for highly available enterprise networks?
sonet ring
When using the world wide web are you using WAN or LAN?
absolutely wan. lan is used for a office or a building complex
What is a Cisco 2600?
The Cisco 2600 series routers are used to tie networks together, usually at the Access level.Each 2600 router has 1 or 2 Ethernet or Token Ring LAN interfaces, a Console and Aux port, and 2 WIC (WAN Interface Card) slots and an NM (Network Module) slot.WIC cards can be used to give the router 1 or 2 Serial WAN connections each, or things like ADSL interfaces, T1 cards, etc.NM modules can be used to give the router things like 2 extra WIC slots, 1 or 4 Ethernet ports, 4 slow serial WAN ports, 16 or 32 serial ports for controlling other routers, and many more.2600 series routers are also obsolete and no longer sold.
Why is it impractical for an organization to own entirety of a WAN?
A WAN is a wide area network that is often used by large businesses or corporations. It is impractical for an organization to own an entirety of a WAN because a WAN is decentralized.
What is the c as defined by LAN or WAN?
A LAN (local area network) is a group of computers and network devices connected together, usually within the same building. By definition, the connections must be high speed and relatively inexpensive (e.g., token ring or Ethernet). Most Indiana University Bloomington departments are on LANs. A WAN (wide area network), in comparison to a MAN, is not restricted to a geographical location, although it might be confined within the bounds of a state or country. A WAN connects several LANs, and may be limited to an enterprise (a corporation or an organization) or accessible to the public. The technology is high speed and relatively expensive. The Internet is an example of a worldwide public WAN.
You cannot ping pfsense fom your wan network?
Add a firewall rule to allow ICMP from WAN. Firewall | Rules | Add Action - Pass Interface - WAN Protocol - ICMP ICMP type - Any (or echo reply) Source - Any If your WAN is a private subnet, you will need to disable block private networks on the Interfaces | WAN page
What is the difference between WAN and LAN?
The other difference between LAN and WAN, is the speed of the network. The maximum speed of a LAN can be 1000 megabits per second, while the speed of a WAN can go up to 150 megabits per second. This means the speed of a WAN, is one-tenth of the speed of a LAN. A WAN is usually slower because it has lower bandwidth. Computers in a LAN can share a printer, if they are all in the same LAN. On the other hand, a WAN cannot share a printer, so a computer in one country cannot use a printer in another country. A LAN does not need a dedicated computer to direct traffic to and from the Internet, unlike a WAN that needs a special-purpose computer, whose only purpose is to send and receive data from the Internet. Another LAN vs. WAN comparison is the cost of the network. A WAN is more expensive than a LAN. It is easier to expand a LAN than a WAN. The equipment needed for a LAN is a network interface card (NIC), a switch and a hub. On the other hand, the equipment needed to connect a WAN to the Internet is a modem and a router. The modem may be a cable modem or a DSL modem that is connected to a wall jack, while the router should be configured so that it can handle the packets traveling between the WAN and the Internet. In LAN vs. WAN, there is a difference in the networking standard used. A LAN uses the Ethernet standard, while a WAN uses the T1 standard. Before Ethernet, the protocols used for LAN were Attached Resource Computer Network (ARCNET) and Token Ring. The protocols used for WAN are Frame Relay and Asynchronous Transfer Mode (ATM). Another protocol for WAN is Packet over SONET/SDH (PoS), where SONET stands for Synchronous Optical Networking and SDH stands for Synchronous Digital Hierarchy. The first WAN protocol was X.25, while an advanced WAN protocol is Multiprotocol Label Switching (MPLS). The hardware in a LAN is connected with 10Base-T cable connectors, while a WAN is connected via leased lines or satellites. Here is an explanation of LANs and WANs. A LAN is easy to set up, as you need to slip the NIC into the PCI slot (for desktop computers) or PCMCIA slot (for laptop computers). You also need to install the driver for the NIC. The NIC can be connected to the network using the RJ45 port. On the other hand, a WAN is very difficult to set up. There is often an appliance to optimize the WAN. There is also a device to cache WAN data, so workers in the branch office can quickly access documents. The router also has Quality of Service (QoS) built in, so that it gives priority to certain kinds of traffic. There are various topologies available in LAN and WAN networking. The most common topologies in LAN and WAN networks are ring and star. The ring topology is a network in which every node (every computer) is connected to exactly two other nodes. The star topology is a network in which all the nodes (called leaf nodes or peripheral nodes) are connected to a central node.
How could one optimize WAN bandwidth?
WAN optimization is used for increasing data transfer across wide-area networks. There are three interdependent components used to optimize WAN bandwidth. They are Traffic Management, Caching and Compression.
What is the Korean word for perfect?
if used as adjective, "완벽한" wan-byuk-han if used as a phrase, like "perfect!" then, "완벽하다" wan-byuk-ha-da
Can you play as obi-wan in battlefront 1?
You cannot play as any heroes or villains in SWBF1
What tests can be used for WAN Failover?
WAN Failover needs to have tests set up for each WAN Interface. These are usually run by qualified computer technicians to avoid glitches in your network.
