0
A Tranzorb connected across the coil of a 24VDC relay will prevent electromagnetically generated transient voltage spikes from damaging the relay coil driver element on de-energization. A Tranzorb placed across the contacts of a relay may help reduce contact sparking, but might more likely revert to the conduicting state - and stay that way - should a transient be generated across the relay contacts on their opening.
The clamping action of a Tranzorb is much sharper and more prompt than that of a Metal Oxide Varistor, or MOV. A MOV, in turn, offers significantly greater transient suppression that a capacitor. Homeowners who operate sensitive digital electronics on the site should know this and condition their mains service accordingly with Tranzorbs, for the sake of long-term harm reduction.
Hope that helps.
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
What is cdg relay?
cdg is circular disk gear relay which is electromagnetic relay
Is a current relay same as potential relay?
current relay are using for over current low state & high state.but potential relay are related to voltage.
How does apfc relay work?
how the apfc relay work
What is the function of static relay?
function of static relay
Where is the 86 lockout relay on turbine?
where is the 86lockout relay on a turbine
Is the reverse current from the transformers can cause a damage to the turbine in power plant?
yes it will be big damages for both that's y fixing differential protection relay between both
Should 2003 beetle cooling fans only work with AC?
its the same problem like the one that im fixing righ now maybe is a colant sensor or a relay
Can a silicon-controlled rectifier stick in on position?
Well a SCR is a solid state device. There are no moving parts inside. So no it could not stick in the on position but it could fail in the on position. When this happens there is no fixing it like a relay. It will need to be replaced.
Where is the fuse for the blower on a Jeep Grand Cherokee?
Look in the fuse box below the glove box on the passenger side in the door pillar. You will find a fuse and a relay there. If that does not fix the blower fan issue, check the post in fixing the blower motor and resistor module.
Blower motor works high speed only?
The Blower Motor Relay is shot! You have 2 one for high speed and one for low, they are located under the dash either in the center of the vehicle or off to the right more near the blower motor itself. In some trucks like my 93 Chevy C1500 the high and the low relay are the same part but in other trucks they are 2 different parts. If your stuck on high the low relay needs to be replaced and on stuck on low the high needs replacing. Happy fixing!
What is auxiliary relay?
An auxiliary relay is a back-up relay in case the primary relay fails.
How many swim in a relay team?
It depends what relay you mean - a normal relay has four swimmers (e.g. an IM relay or a freestyle relay) bu relays such as a cannon relay can have more
What is pick up of a relay?
The "pick up" of a relay is a setting at which the relay will begin to operate. Such as an overcurrent relay - if the pickup is set to 5A, when 5A is flowing through the relay, the relay will operate.
Which relay is the starter relay on a 1994 Buick lesabre?
Which relay is the starter relay on a 1994 buick lesabre
How to find out if a relay is bad?
Swap relay with another like relay.
What is the difference between a relay and an auxiliary relay from constructionapplication poin of view?
I think aux relay is part of relay
Inhibitor relay location 1990 Nissan Stanza?
the inhibitor relay is between the a/c relay and the cornering relay
