You would use gigabit ethernet in a LAN where you want speed; otherwise, most LANs run at 100 megabits per second, which is considerably slower.
If you are talking about a LAN, then just making sure that all devices and cables are capable of gigabit speeds.
Gigabit Ethernet is the term used to describe the transmission of Ethernet frames at a rate of one gigabit per second. It started being used in early 1999.
You would want to move to a Gigabit network. This will require a switch capable of Gigabit speeds, network cabling capable of Gigabit speeds (Cat 5e for example), and a network interface on a computer that is also Gigabit rated. Most modern switches are Gigabit rated (even inexpensive soho switches).
A broadcom gigabit integrated controller is a tenth generation 10/100/1000 base-T Ethernet LAN controller solution. It has high-performance network applications.
Yes, nowadays macs come with 1 Gigabit Ethernet port. check out the tech specs at apple.com
Fast Ethernet runs at 100Mbit and requires CAT5e cables. Gigabit Ethernet is 1,000Mbit and requires CAT6 cables
Gigabit Ethernet almost always runs in full-duplex mode
You would need the ethernet card can handle gigabit network traffic cable.
In order for you to achieve gigabit data rates, you need: * A gigabit Ethernet card (as you have) * A gigabit router * Cabling that is of correct length and quality to carry a gigabit signal. If these conditions are not met, the card will drop to the next available transfer rate.
Ethernet is a set of protocols to establish a LAN.
Gigabit Ethernet is also known as 1000 mega bits per seconds (Mbps). It is a part of the family of Ethernet computer networking and communication standards.
802.11n is rated for a maximum bandwidth of 135Mbps and Gigabit Ethernet (as the name implies) is rated for 1Gbps (or 1000Mbps).