answersLogoWhite

0


Best Answer

The most likely problem is crud in the idle jet..... Happens often... My buddy and I experience this all the time. The new gas with ethanol goes bad fast and algae will start to grow.... We have actually found algae in the carb bowl.... It's a pain in the butt.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why won't a 2003 400 Big Bear Yamaha ATV idle?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

My Yamaha Blaster wont idle?

under the seat where the throdle screws in the carb, there is an adjustment screw, turn right and it increases the idle. it worked for me. do it while running. It is a large flat head screw that is on the throttle body control mechanism. Not on the carburetor itself.


How do you know if carburetor on 4-wheeler big bear Yamaha is bad?

The four wheeler will run for a few seconds then just cut off and it wont have near as much power.


Will a Yamaha Raptor Rear Axle fit a Yamaha Blaster?

no it wont the only other one that will fit is off the banshee


Why wont your Yamaha warrior 350 move forward?

It's in "reverse."


Why won't your 1990 Chevy idle?

1990 gmc p/u 5.7 wont idle showing code 12


What would cause a 2003 Pontiac sunfire to die when it comes to a stop The idle goes all the way to zero and dies. But will start again and if you keep your foot on the gas when stopped it wont die?

possibly idle air control vault getting faulty or restricted air flow


Why won't 1999 Mazda B2500 idle correctly when started cold?

your truck wont idle correctly when its cold, because its cold...and nothing runs correctly when it's cold. your truck wont idle correctly when its cold, because its cold...and nothing runs correctly when it's cold.


Your car will start but wont idle...what is wrong?

Usually the spark plugs or the timing.


Will a 2004 Yamaha YZ-250 transmission fit in a 1999 Yamaha YZ-250?

it probably wont line up correctly with the top end


Why does your 1996 Mazda protege die when you take your foot off the gas it also wont idle?

Try the idle air control motor


Motor stops running i have changed my carby my coil my dizy cap but my car keeps stoppng it starts but want idle unlees reved?

the idle solinoid may need changing, or its power source is not plugged in or working. If the solinoid is not powered the carby wont know where to idle, it will drive fine but wont idle when you pull up at lights ect.


Idle setting for 1995 Isuzu Rodeo 3.2lt 4wd?

u dont set the idle the ecm does the setting througt the air idle conrtol. If it wont idle u need to replace the aic motor on the th0rottle body!