1) A bad fuse
2) The motor pump has failed and needs replacement - easy job to do. Check local auto junk yards or auto parts store.
Toyota previa starter motor wont engage
If you don't hear it running when you press the washer button the motor is probably burnt out.
Ineffective pump, blockage in the lines.
There are a few things to check. First make there is washer fluid in the hold tank. Next check to see if the fuse is still good. Then, check for leak under the car when you turn on the washer fluid to make sure the hoses are not leaking. And finally, you can replace the windshield washer pump if it is bad. This is located at the base of the container holding the washer fluid. Hope this helps to some degree.
check the slave cylinder,if its dry add fluid and then press the clutchin and out about 15 times
my frigidaire affinity washer wont drain
when i try to engage 4xhigh from2xh both 4xh and 4xlow flasg green and wont engage,what could be the problem
Check the trans fluid for water, if you have water you have major problems.
If the clutch won't engage, the clutch disc or pressure plate has probably broke apart. If the clutch won't disengage, the clutch hydraulic fluid reservoir is empty because of a leak in the system.
put tranny fluid in it!
check the lid switch it is under the top of the washer and is usually activated by a pin attached to the lid of the washer
Open hood, look to make sure you have water in the water container, If not add water. if you have water in the container, Then get back in car and start washer motor with switch, listen for motor noise, if no washer motor noise then you have no power to the motor, check fuse. if your washer motor starts then inspect the water lines to the window spray nozzles, starting at water container to fire wall. if all is good then they should work. the only other thing I can think of is the filter on the end of the pick up line in the water container is clogged with dirt. Good luck.