Plugged heads? disconnect and see if fluid runs bad pump? Plugged filter on pump intake?
needs more fluid
It may be that the fluid is frozen, or it may be that the line carrying the fluid is clogged with debris or ice from rain or condensation.
i put a new windshield wiper moter in and the fuses are fine but my wipers still wont work
The back windshield wiper may not be working because there may be a short in the switch. It is best to have an auto mechanic look at it.
Your windshield wipers were most likely overloaded and blew the fuse, try replacing the fuse. If that does not fix it then it is possible that the wiper motor burned out and will require replacement.
If your wipers aren't working then check the grounding screw under the hood if it becomes loose your wipers wont work.
it wont just come out. you need to pump the brake pedal.
Ineffective pump, blockage in the lines.
Just to bug the crap out of you. That is just the way they are. My 95 is the same. Just think happy thoughts when you look out of the windshield. Eventually you wont even notice them any more. Answer, I also have a wrangler 1991 that does that too. It stopped at the bottom to the windshield, until i replaced the windshield. then it started stopping up about 1/3 of the way. I believe that whatever tells the windshield wiper to stop got misaligned, but im too lazy to fix it.
Hi You need to check the fuse first if that's good its got to be either the switch od the motor do you hear any noise when you try ?a click ,moaning,grinding?
no but if you dont check your blinker fluid your car wont start! TRUE STORY!!!!!!!!
in the kick panel on the drivers side forward of the door there is a control box velcroed to the inside. this is the intermittent wiper control box if your wipers dont park or they wont spray windshield fluid this box is more likely the cause. a quick way to test this is to disconnect the box on both ends. then connect the two plugs together. your wipers will work in the low and high position only but they will park when shut off, also the windshield waasher fluid should spray again too. what you need to do is replace that control box, or if you think you can fix it open it up and look for the burnt solder strip on the board. I fixed mine three times this winter alone and all i used was stranded wire copper wire pieces looped around the broken solder strips