I believe you will still have to shift the truck into 4wd inside the cab after locking the hubs on the wheels...I can't remember what year my Dad's F-150 was but he had to lock the hubs on the wheels first then shift the manual shifter inside the truck into 4wd to engage the 4wd feature. If there isn't a manual shift inside the cab, I give!
call up Nissan
Yes. You would need to leave both the transmission and the transfer case in neutral, and leave the hubs unlocked if you have manual locking hubs.
The owners manual states 150 at 2000 RPM
This is spelled out in your owner's manual. It is also listed on a placard under the hood. .033 per chiltons manual
The slave cylinder for the hydraulic clutch on a manual transmission is located inside the manual transmission bell housing
Motorcraft.com shows for a 1985 Ford Truck with 300 cubic inch ( 4.9 L ) straight 6 cylinder ( 10 degrees BTDC ) - doesn't specify automatic or manual transmission
right now ,theirs a1985 Nissan truck service manual on eBay for bid.
The 1985 Chevrolet S10 light truck came factory equipped with the 2.8L 6-cylinder (engine code 'B') in both automatic and manual transmission options. The manual transmission type was the 5-speed F5M22-2.
That diagram should be under the hood on the air filter housing. If not you can find it in a Haynes manual. Just look for the manual for the GVW of the truck.
Try: E-Bay Hemmings Motors Craig's List
where can i find a vaccum diagram for a 1985 Chevy truck with a 350 small block
The 1985 Ford Mustang wheel base is 100.5 inches