0
What else can I help you with?
How do you install an ignition killswitch on a 1990 Honda CRX?
crxresource.org
Crx wont start?
check spark check spark
Why wont my 1991 Honda CRX 1500 fuel injection not idle when it gets warm?
turn down your idle. theres a screw with a spring. right dab in the middle of the manifold with the injectors below the top part of intake. turn it to the left to turn it down. and so on
Where do you spray carburetor cleaner for Honda CRX si?
the crx si is fuel injected so you can spray carb cleaner where ever you want. but it wont be cleaning the carb
Where is the ignition fuse on a Honda CRX?
under the hood on the passenger side on the fender well inside a plastic cover
Can a 1995 Honda Accord vtech 2 L engine fit in a crx?
the engine will fit , but you have to either fabricate or buy some custom mounts, and you wont get to use your hood anymore. the engine is too tall and sticks up out of the bay. i just got a cowl hood for mine,
How do you install an ignition switch 91 crx?
To install an ignition switch on a 1991 Honda CRX, first disconnect the negative battery terminal to ensure safety. Remove the steering column covers by unscrewing the retaining screws, then locate the ignition switch. Disconnect the wiring harness from the old switch and remove it by unscrewing any fasteners. Finally, install the new ignition switch, reconnect the wiring, and reassemble the steering column before reconnecting the battery.
Why wont your 88 crx hf stay running?
maybe the fast idle valve. mine started to die whenever i had that lowered.
Why wont a 1986 CRX start or run for more then a few seconds?
Is there gas in it? if it runs for a few seconds make sure there is fuel in it
Wiring diagram for a 1987 CRX si distributor?
For a 1987 Honda CRX Si, the distributor wiring typically includes connections for the ignition coil, the ignition trigger, and power supply. The main wires are often color-coded: the power supply wire is usually red, while the ignition trigger wire could be green or blue, depending on the specific model. To obtain a precise wiring diagram, it's best to refer to a factory service manual or a reliable automotive repair guide specific to the 1987 CRX Si. This will provide detailed schematics and color codes for accurate wiring.
How do you replace the ignition coil on a 1990 Honda CRX?
The coil and distributor are one unit, there for, no coil wire. Yes it is a sealed unit and has to be replaced as one.
Where is the thermostat located on a 1986 Honda CRX?
its in the front by the hoses, its in the left hand of the engine (top of the radiater to the engine theres three bolts, take hose off then you can see it, u have to put the termostate in the right way or your crx wont run right
