The spark plug tubes need replaced.
you have 2of the plug wires on the wrong plugs or distributor cap
The Sebring is a Chrysler product. Replace the crankshaft position sensor before beginning any diagnosis.
Possible bad valve seals. I have had this problem with my 1999 and that is what I was told.
There could be a few things on a 1995 Chrysler LeBaron causing the distributor not to have power. But first I would check the spark plugs and see if maybe they have gone bad.
if it is getting fuel and spark it could be the map sensor
If you need to ask this question I would recommend getting the plugs done at a mechanic.
Worn down piston rings will allow the oil to seep up into top chamber where the spark plugs are. Otherwise, you just have too much oil in your crankcase.
In the "Chrysler Full-Size Models 1988-93 Automotive Repair Manual" says "Torque Specifications Ft-lbs Spark Plugs to set at "26"
The year, make, model and engine would help us help you.
I would expect to find a loose wire in the connector for the output speed sensor.
1. Make sure you are getting fuel to the carb... 2. If you are getting fuel and spark to you spark plugs and the plugs are wet, You more than likely have a timing problem.
your automatic chock is getting stuck!use some pb blaster on it!