0
It could either be a problem with your 4x4 switch in the cab, the actuator that connects the front right axle shaft to the drivetrain, or the transfer case itself not sending power to the front driveshaft.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
2000 Jimmy 4x4 seems to engage after Jimmy warms up?
no it wont hurt the jimmy
What size is the front axle nut on a 1999 GMC Jimmy 4x4?
35mm
How many gallons of gas does a 1999 gmc jimmy 4x4 hold?
18 GALLONS
How do you replace front wheel bearings on a 1999 Jimmy?
If it is 4x4, you have to replace the whole hub
Where is the 4x4 switch located on a 1999 GMC jimmy 4x4?
well if you dont see it then i highly doubt you even have 4x4 its right in front of your face on the dash on the right side of the steering wheel above your headunit
How do I engage my 4 wheel drive in a 1986 GMC Jimmy 4x4.?
place car in neutral , then bring lever down to 4hi position , then put car in drive.
1999 Chevy blazer the 4x4 is on the dash do you need to be in neutral or park to engage?
The Owners Manual sez to be in Neutral when changing from one mode to the other.
Change 1998 jimmy 4x4 front wheel bearing?
How do you change a 1998 jimmy 4X4 front wheel bearing ?
How do your replace the radiator on a 1999 gmc jimmy 4 dr 4x4 with transmission cooler and engine cooler eoc?
you read the directions!HAHA!
How do you engage 4x4 on 2003 Honda Pilot?
To engage the 4x4 manually (VTM-4), you would need to be in 1st, 2nd, or reverse gear. In those gears and while stopped, you can then press the VTM-4 button, and will engage 4x4. It will only be engaged when around 18mph or lower. Above that, and it will disengage. It will re-engage when it dips down to that speed again. To turn it off, you can just press the button, or shift to a higher gear Keep in mind that even with the button off, VTM-4 will engage occasionally when there's slippage.
What kind of transmission does a 1999 Chevy k1500 4x4 have?
That would be the 4L60E transmission.
Why will my Ford F-150 4x4 will not engage?
Are you in neutral ? No in reverse.
