?? lol i dont know what electro magnets u have been using! if it is a homemade electro magnet, try increasing the coils in the wire ro the power u are putting into it.
does the bar magnet (permanent magnet) have a larger surface area than the electro one? also, you do know that the magnetic potential of electro and permanent magnets vary right? they use electro magnets in junk yards that are capable of lifting scrap cars with eaaase
I'm not an expert, but it would probably be because the two different electromagnetic fields from the magnets are not lining up. This would cause part of the attractive force to be canceled out, and for less paper clips to stick. It really depends on how you have the magnets put together.
it wouldn't be magnet to a aluminum nail because the aluminum is not a way of magnet and a steel nail would because steel is a way of magnet.
It is possible that one magnet is stronger than the other one. It would have to be about 4 times as strong to achieve this result.
If possible cover the magnet with a sheet of paper and gently sprinkle the iron filings over the sheet ot paper, they will stick in a pattern following the magnetic "lines of flux" which will get closer and closer near the poles of the magnet. Afterwards you can cleanup by lifting the sheet of paper off of the magnet and the filings will fall away. Without the paper the filings will usually become tightly stuck to the magnet, making it hard to clean.
aluminum pot
What if there was a magnet glove that would work for the paper clips and stuff that would be really cool
I'm not an expert, but it would probably be because the two different electromagnetic fields from the magnets are not lining up. This would cause part of the attractive force to be canceled out, and for less paper clips to stick. It really depends on how you have the magnets put together.
it wouldn't be magnet to a aluminum nail because the aluminum is not a way of magnet and a steel nail would because steel is a way of magnet.
paper clips
10 paper clips is 7.5 inches, so 7.5X100,000= A million paper clips
Paper clips come in different sizes. A million two-inch paper clips would be two million inches long.
It is possible that one magnet is stronger than the other one. It would have to be about 4 times as strong to achieve this result.
You would need 4 paper clips in order to equal the weight of a pencil.
Yes.
I would suggest you get a sample of 100 paper clips (count them), weigh them, then multiply the result with 54.38. If the weight of the 100 paper clips is too low to get an accurate reading, count off a larger number, and weigh them. In this case, of course, you would have to multiply by a smaller factor.
see if a magnet will stick to it someone who knows stuff about magnets please improve this answer. I myself do not know because a magnet will not stick to a very weak magnet but it is still magnetic. EDIT why would you answer if you don't know the answer? You stroke a bar magnet on the material and after a while it either becomes magnetic or not. unless its already magnetic which you would know straight away because it would stick to the bar magnet. sorry if any of my answer doesnt make much sense ... hope i helped someone
Yes they would but only if the average weight of all the paper clips was 1 gram each.