0
Typically this is because the drain pump has failed or is clogged so you'll get an F02 error. Remove the front panel under the washer door. (3 screws at very bottom front of the washer). In the immediate front of the washer is a big twist knob that turns counterclockwise. Make sure you have a bucket ready as there's 3-5 gallons of water waiting to rush out and greet you!
Once the knob comes loose, give it a gentle pull and it will come out with its attached filter. You'll typically find change, small socks, Shout Color sheets, etc. Get all out and reach in with your fingers to the right. There's a small drain hole there where the pump impeller is. Make sure its clean and free moving. Reassemble the knob/filter and see if you're fixed. If it repeats the error, your drain pump is bad. If you look at most sites, they talk about an ASKOLL M75 pump. Whirlpool only sells the full pump and housing assembly and it will cost you between $95 and $200. It is listed as part # 280187.
The same motor is available for GE models as the WH23X10013 and I've found it as cheap as $19 !!! Now of course, all you get is the motor and not the full drain assembly, but it's the part that failed, not the drain assembly! Save your money folks!
The GE motor mentioned above will work but minor modifications will be needed to connect the power (remove the orig plug and attach new plugs and/or solder to motor assembly). I just did this myself and yes, saved big time over the original pump from ASKOLL. :)
What else can I help you with?
Where can I find whirlpool duet washer parts for purchase?
You can find Whirlpool Duet washer parts for purchase at authorized Whirlpool dealers, online retailers like Amazon or eBay, or directly from the Whirlpool website.
Can you reverse door on whirlpool duet washer?
Yes!
How do you remove pedestal from whirlpool duet washer?
removefourscrews
Where can one purchase a Whirlpool duet washer?
A Whirlpool Duet Steam Front Load Washer 4.5 cu. ft. is available for purchase online on the Amazon website. It is an energy star qualified washing machine and features advanced water and energy savings.
How do you wash shoes in the whirlpool duet washer?
Get yo shoes and stuff them inside the washer,, and den press START!!The End!
How do you spin dry whirlpool washer duet?
A big red alien comes down from the sky and zaps your washer and then it spin drys!
Why won't the Whirlpool Duet washer door unlock?
The Whirlpool Duet washer door may not unlock due to a malfunction in the door lock mechanism or an issue with the control panel. It is recommended to unplug the washer for a few minutes and then try to unlock the door again. If the problem persists, it may require professional repair.
If I want the most energy efficient washer, what one would I buy?
Whirlpool WFW8300SW White Duet Sport Front Loading Washer is a good enery efficient washer.
What does a flashing F1 code mean on the whirlpool duet sport washer?
commuication error between ccu and mcu
Why is my Whirlpool Duet washer door locked and not opening?
Your Whirlpool Duet washer door may be locked and not opening due to a malfunction in the door lock mechanism or a problem with the control panel. It is recommended to unplug the washer for a few minutes and then try to open the door again. If the issue persists, you may need to contact a professional technician for further assistance.
How do you install a shock absorber for whirlpool duet washer?
To install a shock absorber for a Whirlpool Duet washer, start by unplugging the washer and locating the shocks at the front and rear of the washer. Remove the screws securing the shock absorber in place, then swap out the old shock absorber with the new one. Secure the new shock absorber with the screws and plug the washer back in. Run a test cycle to ensure proper installation.
Why won't my Whirlpool Duet washer unlock?
There could be several reasons why your Whirlpool Duet washer won't unlock. It may be due to a malfunction in the door lock mechanism, a problem with the control board, or an issue with the power supply. It is recommended to unplug the washer for a few minutes and then try to unlock it again. If the issue persists, it may require professional repair or troubleshooting.
