After some work on the vehicle such as replacement of the main vacuum system, when the cruise control is disabled during the work, it looses its communications with the main system. The only way to fix this is to have the programing uploaded to it by a Ford dealer.
Did you get the a RECALL notice ? Regarding the cruise control ... Ford put out a RECALL on the cruise control last year... I just had mines done on my 98 Ford Expedition XLT last week.
the cruise control is broken....
BROKEN CRUISE CONTROL CABLE (CHECK AT THROTTLEBODY AND FOLLOW TO TRANSMISSION)
my control cable frayed....
There is no fuse for the cruise control on a 1994 Acura Integra. It is a relay switch under the hood near the battery. This would have nothing to do with the dashboard clock, if the cruise control is not working properly. If the cruise control is not coming on, check the relay, then check the carburetor or EFI (Electronic Fuel Injector). Also, the cruise control will not come on if the brake light switch or the clutch is not working properly.
check to see if your spoiler brake light is out replace it and it usually will finish the ground to the abs sensor and cruise control
Blown fuse would be where to look first.
if it is a explorer or a expedition from Ford I would ck the deactivation switch on the master cyliner and see if it is leaking brake fluid if it is then replace and cruise will work again !!! Timberland Ford Florida Service Manager !!
It is possible that both of the fuses are bad for the low beam headlights and the cruise control. A loose ground wire could cause the fuses to blow.
Check your fuses first; you may have a bad fuse.
vacuum or electric what should i look for
There are a few reasons why the cruise control does not work in a car. The fuse could be out, the wiring could need replacing or something as simple as the buttons not working.