0
Why would the ignition all of a sudden lock on a 1988 BMW 7-Series when all the electrical systems seemed to be working fine?
Wiki User
∙ 10y ago
Answer
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
What is the function electrical engineer in banking sector?
Many banks will hire an electrical engineer to assist with their online, phone, and e-banking systems. The engineer will be working with the networking and hardware to insure the systems are running properly.
Why is the security light on after you changed ignition keys?
The security light comes on after you changed the keys in the ignition from the off position to the on position as a confirmation that the electrical components in the dash board are working. It is nothing to be concerned about.
Where is the most common place for an electrical short in a 1987 Ford Thunderbird?
there are many different electrical circuits in a car. you would have to be more specific as to what exactly is shorting out, i.e. lights, audio, ignition, so on and so forth. tell me whats not working and maybe i can help you. there are many different electrical circuits in a car. you would have to be more specific as to what exactly is shorting out, i.e. lights, audio, ignition, so on and so forth. tell me whats not working and maybe i can help you.
Describe safe isolation procedure for safe systems of working in electrical circuit?
Shut it off and lock it out. Sign the lockout card and keep your key with you.
Why does the fuel pump stops working when you hit the ignition?
The fuel pump may stop working when you hit the ignition due to the mechanical failure.
Are electricial prints energized whe you read them or deenergized when you read them?
Electrical prints are typically read when the electrical system is de-energized for safety reasons. Working on live electrical systems can be extremely dangerous, so it is standard practice to de-energize the system before reading electrical prints or performing any maintenance or repairs.
Why BMW x5 alarm is not working after dead battery?
All electrical systems require voltage to operate, normally 11.5-12v, computers wont function properly below that.
How do your RPMs stop working?
RPM is the abbreviation for revolutions per minute and is a measurement of the revolutions of the engine crankshaft. Literally, if your "RPMs stop working" your motor isn't running. However, you are probably referring to the tachometer, the meter that displays the number of rpm's your engine turns, that has stopped working. There are two basic types of tachometers: electrical and mechanical. Electrical tachometers calculate the engine speed by counting electrical pulses while the mechanical tachometers have a mechanical cable attaching to the engine, generally the ignition distributor or camshaft. So, if your tachometer is not working you have either have an electrical problem, a broken cable or the meter itself has become defective.
Could ignition cause sudden engine failure?
Ignition is required for an engine to work. Failure of ignition would prevent the engine working.
How do you remove and install the ignition switch on a 91 Ford Explorer?
I am working on changing my 93 Explorer ignition switch now. As soon as I figure it out I will let you know. :-) Still working on it.
Is a relay and electronic spark advance or timing advance or timimg retard systems are same?
Basically it's, because on Camry the ignition system is managed by computer with feedback system working through numerous sensors.
How can one prevent electrical accidents?
Electrical accidents can be prevented by ensuring the electricity is switched off before working on anything electrical. Wearing rubber shoes when working with electricity is also recommended.
