0
What else can I help you with?
How much horse power does a Plymouth sundance have?
Depends on the engine
What is the purpose of the thermostat power wire in a heating and cooling system?
The purpose of the thermostat power wire in a heating and cooling system is to provide electrical power to the thermostat, allowing it to control the temperature settings and activate the heating or cooling system as needed.
What type of steering system does the Plymouth duster use?
The 1971 Plymouth duster uses a power steering system ..... Have a good day
Where is fuel pump relay on 1988 Plymouth sundance?
On a 1988 Plymouth Sundance, the fuel pump relay is typically located in the power distribution center or fuse box, which is found under the hood near the battery. It may also be mounted on the driver's side of the engine compartment. Consult the owner’s manual for specific diagrams and locations, as configurations can vary.
What kind of power steering fluid does a 2002 Plymouth voyager use?
The power steering system on a 2002 Plymouth Voyager uses automatic transmission fluid.
Where is the asd relay on a Plymouth sundance?
The ASD (Auto Shut Down) relay on a Plymouth Sundance is typically located in the power distribution center under the hood of the vehicle. It is often found near the battery, inside a black plastic box that houses several fuses and relays. You may need to refer to the vehicle's owner manual or a wiring diagram for the exact location and identification of the relay.
What is the purpose of the thermostat R wire in a heating and cooling system?
The purpose of the thermostat R wire in a heating and cooling system is to provide power to the thermostat, allowing it to control the heating and cooling equipment in the system.
You have no power to the coil on a 94 Plymouth sundance What is wrong?
If there is no power to the ignition coil on a 1994 Plymouth Sundance, the issue could be due to a faulty ignition switch, a blown fuse, or a problem with the wiring harness. It's also possible that the coil itself is defective or that there's an issue with the engine control module (ECM) not sending the signal to activate the coil. Checking the voltage at the coil, inspecting the fuses, and testing the ignition switch can help diagnose the problem.
What kind of Power steering fluid for a 2000 Plymouth Neon?
The system uses regular power steering fluid.
How can I ensure the proper installation of a thermocouple in my heating system?
To ensure the proper installation of a thermocouple in your heating system, follow these steps: Turn off the power to the heating system. Locate the old thermocouple and remove it carefully. Install the new thermocouple in the same position and secure it properly. Reconnect any wires or connections. Turn the power back on and test the heating system to ensure the thermocouple is functioning correctly.
How can I install an 8 wire thermostat in my home heating system?
To install an 8 wire thermostat in your home heating system, you will need to first turn off the power to the heating system. Then, remove the old thermostat and label the wires according to their corresponding terminals. Next, connect the 8 wires to the appropriate terminals on the new thermostat following the manufacturer's instructions. Finally, secure the new thermostat to the wall and restore power to the heating system.
What is the significance of RC and RH on a thermostat?
The significance of RC and RH on a thermostat is that they are terminals for connecting the power source to the heating and cooling systems, respectively. RC is for connecting the power source to the cooling system, while RH is for connecting the power source to the heating system. These terminals ensure that the thermostat can control both heating and cooling functions in a home or building.
