0
Why would you not connect a 6 v battery into a circuit that requires a d cell?
Wiki User
∙ 9y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why should you not connect a 6 V battery into a circuit that requires a D cell?
A D cell battery supplies nominally 1.5V. Connecting a 6V supply in it's place would supply an extra 4.5V and could potentially damage the circuit components.
Should AC circuits go to or from positive battery terminal?
You would never connect any part of an AC circuit to a battery.
What are all the parts on a circuit board?
to assemble a circuit you just need to connect one end of a wire to the battery and the other to the light bulb ( could be another electrical device) now take an other wire and connect on end of it to the other side of the battery and the other to the other side of the light bulb( or an other electrical device. if your circuit is including a switch this is how you do it: ( you will need three wires for this circuit if you have one electrical device) connect one end of the wire to the battery and the other to the switch.Grab another wire and attach one end of it on the other side of the switch and the other to the electrical device (light bulb). Grab another wire and attach one end of it to the other side of battery and the other to the other side of your electrical device. And there you have it how to assemble a circuit
Should you connect the pos or neg terminal first when replacing a car battery?
Assuming the vehicle has a negative earth You connect the positive lead first The reasoning When the positive lead is fitted first, if you dropped a spanner across the battery negative terminal to the car body all you would do is make the circuit. If you connect the Negative lead first, and you dropped a spanner across the positive battery terminal to the car body you would then have a dead short
What would happen if a battery is removed from a circuit?
It wil be on
What are the circuit effects due to a short circuit or open circuit?
It would depend on the circuit diagram. In some cases, the circuit would be incomplete (simplest case is a battery with a wire attached to just one terminal).Parallel branches that have a connection to the battery without going through other branches are independent of each other. Say you have two parallel branches and a battery. If you short circuit one of the branches, the other branch will not be affected but the battery will be (current through the battery would decrease because taking out a parallel branch increases resistance).In short, it would depend on the circuit diagram. Note that for a nanosecond, there would be current in an open circuit, but after this brief time there would be no current flow in the segment of the circuit that has been shorted.
How would one replace a car inverter?
For powering a load over 150 watts, you can connect the inverter directly into your car battery. This involves using a 4-guage power cable that draws directly from the positive battery terminal. Without an in-line fuse or circuit breaker, you could short circuit the process.
What happens when you disconnect the wire from the battery?
Disconnecting a wire from a battery would break the circuit. If the battery was powering a bulb, the lamp would go out.
When you add a second battery to a series circuit what happens?
Adding a seound battery to a series circuit will increase the voltage, and require less current to keep the lights (if there are any on) as bright. Say you have a 6v battery, then you add another 6v battery. the voltage of the circuit would be 12v
What would the current flow be if a short circuit is put across the battery's terminals?
That will depend on the internal resistance of the battery. I = E / R Where I is the current, E is the open circuit battery voltage, and R is the internal resistance of the battery.
Why would you connect wires to a penny?
Answer why does the person who made a circuit a probably connect the wires to a penny
How would the circuit inside a flashlight work?
Flashlight by light, battery, circuit, a hood and a reflective cup, circuit storehouse, switch, etc, the basic principle is the current from the battery, and then to the circuit, after adjusting circuit voltage and current, and then output to the light source for lighting.
