0
What else can I help you with?
Which terminal should you connect first when jump-starting a car battery?
When jump-starting a car battery, you should connect the positive terminal first.
How do you jump start two 12 batteries?
To jump start an engine via the battery; the remote battery and the host battery, being of the same voltage, should be connected in parallel. That is positive terminal to positive terminal, negative to negative.
Should you reonnect the positive or negative battery terminal first?
Reconnect pos first
Could a bad key switch cause the positive battery terminal to get hot?
No, the battery terminal should be able to handle as much electrical current as the vehicle should ever use, WITHOUT heating up. Clean or replace any battery terminal that is getting hot.
Which battery cable should be reconnected first?
Positive should always be connected first. The pull of electrons toward the positive terminal will cause a spark.
Should you disconnect the positive or negative battery terminal first - 45k?
Always the negative cable first.
Where do you put the positive cable to charge the battery i can see the negative it is on the passenger side?
The positive terminal of the battery will be encoded with Red color (either painted or a plastic cover that lifts off) and should also have the marking "+" on it. The negative terminal is encoded with black paint or cover and should have a "-" mark.
How do you replace the battery in a 2004 mini cooper S?
The battery should be in the hatch compartment (behind the rear seats), under the floor mat. Disconnect the negative terminal (black), then the positive terminal (red). Remove the battery, and install the new one in the same position. Reconnect the positive terminal, then the negative terminal. NOTE: The terminals are also designated by plus or minus symbols.
Replace battery 2004 Dodge Durango?
REMOVAL Turn the ignition switch to the Off position. Be certain that all electrical accessories are turned off. Loosen the battery negative cable terminal clamp pinch-bolt hex nut. Disconnect the battery negative cable terminal clamp from the battery negative terminal post. If necessary, use a battery terminal puller (2) to remove the terminal clamp from the battery post. Loosen the battery positive cable terminal clamp pinch-bolt hex nut. Disconnect the battery positive cable terminal clamp from the battery positive terminal post. If necessary, use a battery terminal puller (2) to remove the terminal clamp from the battery post. Remove the battery cables from the battery. Remove the battery thermal guard (1). Remove the battery hold down bolt (1) and battery hold down (2) from the battery. WARNING: Wear a suitable pair of rubber gloves (not the household type) when removing a battery by hand. Safety glasses should also be worn. If the battery is cracked or leaking, the electrolyte can burn the skin and eyes. Remove the battery from the battery tray.
Positive car battery terminal gets too hot to touch is that normal?
No, Remove the terminal and clean with wirebrush until both the clamp and battery post are shiny.Re-install.The heating problem should be eliminated.
How do you use jumper wire to roll up power window?
To roll up a power window using jumper wires, first, locate the window motor's terminals, usually found in the door panel. Connect one jumper wire to the positive terminal of the motor and the other end to the positive terminal of the car battery. Then, take another jumper wire, connect one end to the negative terminal of the motor, and touch the other end to the negative battery terminal. This should power the motor and raise the window; be cautious to avoid short circuits and ensure safety.
How do you remove the battery out of a 1992 lumina?
Start by locating the Positive terminal (usually the red one)... Disconnect it from the battery. Then do the same for the Negative terminal (the black one). Then there may be a small hex head bolt at the bottom the the battery, check for it and remove it, the battery should come right out.
