answersLogoWhite

0

because the bearings in them were incorrectly manufactured. There was a recall on this issue

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What is mystic gohan?

Mystic Gohan is the name given to Ulimate Gohan by fans. He is basically Gohan after his hidden potential is fully unlocked by Elder Kai in Dragon Ball Z during the Majin Buu Saga.


Where can you find the fuse that controls the fans for a 2001 Mercury Sable?

Heater blower fans or engine cooling fans????? See "Related Questions" below for both.


What are the release dates for Tie-died Rock 'n Roll's Most Deadicated Fans - 1995?

Tie-died Rock 'n Roll's Most Deadicated Fans - 1995 was released on: USA: 22 September 1995


Why doesn't the cooling fans turn on in my 1995 integra?

There is prob a bad relay that's not triggering the fans to turn on.


How do you test my cooling fans on a 1995 Mazda 626?

rggerger


When do the radiator fans come on in a 1995 Chevy Monte Carlo z34?

The fans are controlled by a temperature switch, which normally turns the fans on when the engine temp reaches about 212 to 220 degrees.


1995 z28 car fans come on at high temp?

230 degrees


How do you fix coolant problems with 1995 trans am?

First you would have to check to see if you're leaking antifreeze from any of your hoses or the radiator itself. Then I would see if the cooling fans come on, usually around 225 degrees.


Would Austin date one of his fans?

austin would probably date one of his fans its possible


How do you change fan belt 1995 Toyota Celica?

Fan belt? Well a 1995 celica would have either a 5S-FE (2.2L)or a 7A-FE (1.8L)engine. Both of these motors use electric fans. I am not sure which belt you are trying to change.


What would cause the coolant fans to stop working on a 1995 ford contur?

More than likely the radiator fan resistor has gone bad. It is located at the bottom corner of the radiator.


What do you do when both fans stop working in a 1995 Monte Carlo?

if both fans quit working, it could be as simple as the relay fuse going out. have your mechanic check these fuses.