yes
Brake light switch ?
Check the switch at the brake pedal .
Check the tail light bulbs, clean it if you have using fine sandpaper. If it did no work check the cable connected to the lights. If the cable integriry was not damaged, check the fuse box.
Test the wires especially contacts, use fine sandpaper to remove oxidation.
94 mercury grand marque dashboard, hazard, and tail lights do not work?
There is a relay in the trunk (left hand side wall) that may have been burnt. You may want to check this out...had the same problem with my 1992 Camry.....different year of course. The wires to the running lights were broken and exposed, caused a short, which in turn burnt the relay in the trunk.
Are you saying your tail lights themselves do not work and only the brake lights work. If that is the case, check the fuse, and then check the tail light bulbs.
The tail lights and the stop lights work off of different circuits. The stop lights work when the brake pedal is depressed while the tail lights work when the light switch is turned on. Look for a burnt fuse or a bad connection.
Check the fuse box. The problem is probably a burnt out tail-light switch.
THIS DID NOT WORK ON MY 2007 CAMRY..ANY OTHER SUGGESTIONS??
If the headlights are on and brake lights work but not the tail lights, it is possible there is a short in the electrical wires. Another cause for this could be that the tail light bulbs are burned out. Most vehicles have more than one bulb inside the tail lights to control different lights at the same time.
The brake lights are a separate circuit from the tail lights. If the bulbs and fuse checks okay, I would suspect the brake light switch is at fault.