Should fit, yes
To remove the plastic cover around the steering column of a 1994 Jeep Cherokee, start by disconnecting the vehicle's battery to ensure safety. Next, locate and remove the screws or bolts securing the cover, usually found at the bottom or sides of the column. Gently pry apart the two halves of the cover, taking care not to damage any clips or tabs. Once detached, you can access the steering column components as needed.
the 1994 'burban steering column is generally the same as all GM light truck steering columns from previous years. Same tools, Same disassembly removal procedures
On firewall, above the steering column On firewall, above the steering column
On a 93 it is a lever located on the bottom of the steering wheel column. Bang your knees on the bottom of the steering wheel column and you will proabbly hit it.
The shift lock solenoid is located on top of the steering column. You will need to remove the steering column covers, lower dash trim, and the heater duct. Remove the steering column bolts and lower the steering column to access the shift lock solenoid.
Short in the wiring with the steering column.
Lower the steering column.
found out 1997 to2001 will interchange but not all pumps will work check bolt patterns
Dead short to ground in steering column
right behind the sterring wheel on the steering column
It should be the stalk on the left side of the steering column behind the steering wheel
To remove the steering column on a 1994 Buick Roadmaster, first disconnect the negative battery cable to prevent electrical issues. Next, remove the screws securing the plastic cover around the steering column, then take off the cover. After that, disconnect the wiring harness and any associated components like the ignition switch and turn signal assembly. Finally, unbolt the steering column from the dashboard and steering gear, and carefully slide it out to access the ignition.