0
As far as fitting in the truck YES.
Hear's the problem that you will have. First it won't even run because the wireing harnesss and computer system / ECM. Engine controll module was designed for a VORTEC engine. none of the wireing harness will hook up to the 92 350 engine.
To make the 92 engine run correct with NO TROUBLES. You will have to have a 92 ECM / computer system and a 92 model transmission and the intire engine wireing harness for a 92 model. You will also have to change the fuel pump.
Your best bet would be to put a VORTEC ENGINE from 1996 to 1999 back in it.
What else can I help you with?
What is dwell setting for 1972 350 chev pickup?
30 degrees
What is the spark plug gap setting for 1979 Chev 350 K20 pickup?
0.060
What is the torque for the dome and heads for a 1987 chev 350 pickup?
Torque for the dome???????????????????????? What the heck is a dome?????????
How to replace a Ford f-350 starter?
How do you replace a starter in a 1997 F-350 Turbo Pickup?
Where is the oil pressure sending unit on a 1992 chev 350?
Top rear of engine, close to the distributor.
How many oxygen sensors on 91 chev silverado pickup 350 motor?
It has 2 ^wrong tbi motors only have 1 and its on the drivers side.
How much oil does a 1992 Chevy 1500 5.7L V8 pickup oil pan hold?
The "Stock" pan holds 5 quarts. However... there are after-market pans and even some original equipment "high volume" pans that have been used on the Chev 350.
What is the horsepower of a 1997 Chevy 1500 pickup with a 350 vortec v8?
250-290 hp
What kind of antifreeze should be used in a 1997 Chevy pickup 350 Vortec?
long life
Was their a small journal 350 Chev engine?
No.
Does a 86 350 chev truck have points?
no
What is the fuel pressure spec for a 1992 350 pickup with 360 tbi?
9 to 13 LBS. No higher or lower, are you will have problems.
