Alternators
Ford Probe

Will a 1994 Ford Probe Alternator fit on a 1993 Ford Probe gt?

789

Top Answer
User Avatar
Wiki User
Answered
2010-10-14 04:48:53
2010-10-14 04:48:53

if the 94 probe is a GT, yes.

the 2.0l alternators are different from the GT

the autozone part numbers for the 94 2.0L Probe is 14449 and the part number for the 94 2.5L GT is 14450

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


the alternator is located on the passenger side of the motor towards the bottom front.



In the alternator. Have to replace the Alternator.


diagram of starter in a 1993 ford probe



ford probe gt rims are 7 inch


no, the 89-92 engine/transmissions are different from the 93-97 ford probe.


Were do I locate the fuel filter on a 1993 Ford probe 4 cylinder


I have a 97 Ford probe and when I had to replace my alternator... I had to pulled the passenger tire off and pull the whole assembly apart so I could get the alternator.. There are 2 bolts to loosen up and pull the belt out slide the alternator down by the exhaust and pull it out by the CV axle


stock enginestock engine in 1994 ford probe GT is a Mazda 2.5L 24 valve V6.


what is the spark plug gap for an 1989 ford probe lx? Thank you.



its a Mazda engine . ( DOHC 4cyl. 16 valve 2.0l ) For the probe 1993


The 1994 Ford Probe has a brake fluid reservoir that should be mounted on the drivers side firewall. Remove the cap on top to add fluid.


I want to know what is the proper spark plug gap for my car. It's a Ford Probe 1994, 4 cylinders and 2.0L


The voltage regulator is on the alternator. It is all one piece.


your firing order for your probe is 1-4-3-2


In the fuse box, under the hood, behind the battery. It will be a green relay. Maybe this will help : http://mysree.wordpress.com/2007/12/11/fuse-diagrams-and-specs-for-1994-ford-probe-gt-v6/


hi, i could'nt find the inertia switch on my ford probe 1994 for ages. Eventually I found it just above the wheel arch on passenger side in boot but you have to remove the plastic covering. Not easy to locate. Hope this helps.


Yes,but the 93 and 94 enginges are obd1,while the 95-97 are obd2.


Subaru wheels do not fit on a 1994 Ford Probe because of fundamental design differences. Both have a similar appearance, however the bolt pattern and sizes are different.


Maybe this will help : http://mysree.wordpress.com/2007/12/11/fuse-diagrams-and-specs-for-1994-ford-probe-gt-v6/



it is located inside the fuel tank


---- ---- == == ---- == == ---- == == ---- == == ---- ---- == == ---- == == == == == == == == == == == == == == == == ----



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.