No.....They look the same but they are not the same. The wires have been put in different places.
You can order a new engine wiring harness for a 92 Cavalier 3.1 at auto part stores. You can also check with a certified dealer.
You can swap the engine from your 1997 Cavalier 2.2 liter engine to your 2000 Chevy Cavalier. The wiring harness and motor mounts should be in exactly the same.
I have one, 479-462-1270
The 1997 Chevrolet Cavalier motor will fit into the 1997 Pontiac sun fire. The motor mounts and the wiring harness are exactly the same.
The wiring on the back of your 2000 Pontiac alternator consists of a wiring harness. The wiring harness goes to a few relay switch is and regulators.
Pontiac 2400yes but wiring harness may need to be changed.
No....I got to work on a GT Sunfire wiring harness after the ECM fell out of the car and was run over which ripped the wires out.After trying to connect them(which was a losing battle from the get-go) I learned that several wires on the sunfire went into different terminals on the computer.
Under the dash on the driver side. Follow the wiring harness back from the fuse box. It's about six inches back and is taped on to the wiring harness.
yes, it can work however your going to need the engine, transmission, ecu, wiring harness, and bcm, and someone who knows how to fabricate new engine mounts and trans mounts, its quite a costly engine swap, but with lots of money and time just about anything can be done
No you have to disconnect the wiring under the dash.
They are a dealer item and can be found online, maybe Ebay, also at a salvage yard. But expect to pay $1200 for a brand new harness. In 1999 they started coming without/EGR.
Engine wiring harness is primarily used to control fuel and ignition timing. Switches, sensors and actuators are also some of the other components that are related to vehicle engine control.