No, 120 v is not enough.
you can't
Yes, no problem.
nothing
No
Yes no problem the transformer should run a little cooler as well.
Yes, using a 220v-60hz microwave in Australia is fine. The voltage of alternating current supplied to homes in Australia is 220v. The frequency of the voltage is 50hz.
More than likely yes it will work just fine.
yes.
You can use a frequency converter to change the output frequency of the inverter from 60Hz to 50Hz. This will allow you to use devices that are rated for 50Hz frequency with your 110V 60Hz inverter. Just make sure to select a frequency converter that is compatible with the power output of your inverter.
You can purchase an inverter that accepts 220 VAC 50Hz input and produces 120 VAC 60Hz output. You can purchase an inverter that works from single phase or three phase electricity and can produce single phase or three phase output. You must specify the 120 VAC current load when choosing the inverter. You must also be sure the 220 VAC 50 Hz supply has sufficient current capacity to operate the inverter with the required 120 VAC current load. The inverter works by rectifying the 220 VAC 50 Hz input into DC energy. The inverter then uses switching solid state components to produce 120 VAC 60 Hz output from the DC energy.
No. For more information see the answers to the Related Questions shown below.
No! Normally not, the recistance in the windings is to hig on 60Hz and the pump motor has not power enough to work propelly. This happened to myself when I connected my Whirpool AWE 7519 to 230V 60Hz. Europian model for 50Hz.