answersLogoWhite

0

It will physically fit into the engine bay.. Yes. But it is not a direct drop in. You will need a lot of custom fabrication work to make a running car with it.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you change a 3.9L to a 318 in a Dodge d150?

Eng,trans,drive shaft


Where is the oil sensor on a 1993 Dodge Ram with 318 Eng?

Back of the block, next to the distributor.


Where is temp sending unit on 73 dodge Dart 318 eng?

Close to the thermostat housing.


How do you install a chevy 350 in a dodge d100?

BIG job,costly. Replace with mopar eng. 318-360.


Is it true your alternator on 91 dodge Dakota 318 eng is regulated from the main pcm?

Yes , the PCM is the voltage regulator.


WHERE IS THE PCV VALVE ON A 2007 DODGE DAKOTA 4.7 ENG.?

Where is the pcv valve on 2007 dodge dakota 4.7 mag. Eng.and the egr valve also?


Where can i get free van Diagrahms?

Im need a fuse box identification diagram for a 1987 dodge ram van b-250 / 318 eng. size.


How do you line up the timing marks on a 1970 dodge dart 318 eng?

the cam gear slot is set at 6:00 and the crank gear slot is at 12:00.


How do you find out what transmission is in 1990 dodge b250 van with 318 eng?

To determine the transmission in a 1990 Dodge B250 van with a 318 engine, you can check the vehicle's owner manual for specifications. Alternatively, you can look for identification tags on the transmission itself, typically located on the driver's side or rear of the transmission housing. Additionally, you can inspect the vehicle's VIN, which may provide information about the original drivetrain options. If you're still unsure, consulting a local mechanic or a Dodge dealership could help confirm the transmission type.


What is the fieing order for 318 reverserotation eng.?

1 8 4 3 6 5 7 2 is the firing order.


Where is temp sending unit on 97 dodge ram 318 eng?

The guage sending unit is a very small single wire sensor located next to the thermostat housing. follow the upper radiator hose down behind the air compressor to the intake. it'll be next to that.


What is the sparkplug gap for a 2001 dodge ram 5.9 eng?

0.040 inch